Repareer je spullen Gemeenschap Winkel

Ryobi RJ1861V Saw Bar Assembly Replacement

Inleiding

This guide demonstrates how to remove and replace the saw bar assembly in a Ryobi RJ1861V reciprocating saw.

Wat je nodig hebt

  1. Ryobi RJ1861V Saw Bar Assembly Replacement, Saw Bar Assembly: stap 1, afbeelding 1 van 1

    • Use a Torx T5 screwdriver to remove the single 8 mm screw securing the shoe.

    Bewerken

  2. Ryobi RJ1861V Saw Bar Assembly Replacement: stap 2, afbeelding 1 van 2 Ryobi RJ1861V Saw Bar Assembly Replacement: stap 2, afbeelding 2 van 2

    • Remove the rubber sleeve.

    • You may have to use some force as it has a tight fit.

    Bewerken

  3. Ryobi RJ1861V Saw Bar Assembly Replacement: stap 3, afbeelding 1 van 1

    • Use a Torx T5 screwdriver to remove the six screws on the underside of the device.

    Bewerken

  4. Ryobi RJ1861V Saw Bar Assembly Replacement: stap 4, afbeelding 1 van 1

    • Use a Torx T5 screwdriver to remove the four screws on the top of the gear case.

    • There are two screws on each side of the device.

    Bewerken

  5. Ryobi RJ1861V Saw Bar Assembly Replacement: stap 5, afbeelding 1 van 1

    • Remove the backside panel.

    Bewerken

  6. Ryobi RJ1861V Saw Bar Assembly Replacement: stap 6, afbeelding 1 van 1

    • Unscrew the four T5 Torx screws that hold the assembly bar in place.

    Bewerken

  7. Ryobi RJ1861V Saw Bar Assembly Replacement: stap 7, afbeelding 1 van 1

    • Lift the assembly bar up and out of the chassis.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 1

Afgelopen 7 dagen: 11

Afgelopen 30 dagen: 30

Altijd: 869