Roconia Q6 OK Button Replacement

Inleiding

This manual provides instructions for changing the Ronconia Q6 projector's OK button. The OK button is crucial for menu navigation and selection confirmation. Whether you're a novice or experienced, this guide offers straightforward, easy-to-follow steps to simplify the replacement process.

Wat je nodig hebt

Stap 1 Top Cover

Roconia Q6 OK Button Replacement, Top Cover: stap 1, afbeelding 1 van 2

Roconia Q6 OK Button Replacement, Top Cover: stap 1, afbeelding 2 van 2

Flip your device upside down so that the interface is facing downwards.

Vertaal

Stap 2

Roconia Q6 OK Button Replacement: stap 2, afbeelding 3 van 3

The device is supported by rubber pieces located at the bottom extremities.
There are screws beneath the rubber pieces that can be removed. Remove all four 1.1 mm Phillips #1 screws by using the Phillips #0 screwdriver.

Vertaal

Stap 3

Roconia Q6 OK Button Replacement: stap 3, afbeelding 3 van 3

Turn device over again and pry open the device to remove the cover.

Vertaal

Stap 4

Roconia Q6 OK Button Replacement: stap 4, afbeelding 3 van 3

Pull out the cable that is connected to the top cover to fully separate.

Vertaal

Stap 5 OK Button

Roconia Q6 OK Button Replacement, OK Button: stap 5, afbeelding 1 van 2

Roconia Q6 OK Button Replacement, OK Button: stap 5, afbeelding 2 van 2

Use a Phillips #0 screwdriver to remove each of the 5.2 mm screws from the sensor board inside the cover.

Vertaal

Stap 6

Roconia Q6 OK Button Replacement: stap 6, afbeelding 3 van 3

Remove the motherboard and you will see the the pieces that help control the buttons.
Locate where the OK button is placed.
Remove the part that helps control the OK button by pulling it out