Inleiding

This page is for disassembling the speaker inside the device. Before following these steps, please refer to the Disassembling VTech MobiGo Touch Learning System Case Guide first.

Wat je nodig hebt

Stap 1 Case

Replacing VTech MobiGo Touch Learning System Speaker, Case: stap 1, afbeelding 1 van 1

Remove the battery covers and the four batteries.

Bewerken

Stap 2

Remove the four plastic caps with a metal spudger to expose the 6.0 mm Philips JIS #0 case screws.
Remove the eight 6.0 mm JIS #0 case screws.

Bewerken

Stap 3

Using a plastic opening tool, separate the two pieces of the case carefully.

Bewerken

Stap 4 Speaker

Replacing VTech MobiGo Touch Learning System Speaker, Speaker: stap 4, afbeelding 1 van 2

Replacing VTech MobiGo Touch Learning System Speaker, Speaker: stap 4, afbeelding 2 van 2

The speaker will be attached to the back of the case.
Unscrew the two 6.0 mm Philips J0 screws.
Careful! The wires are still attached to the back of the case and to the speakers.

Bewerken

Stap 5

Lift the round speaker with a plastic opening tool.
Remove the two wires connected to the speaker.
You can use wire cutters or regular needle nose pliers to disconnect the wires from the speaker.
Once the wires are disconnected, remove the speaker from the back of the case.

Bewerken

Stap 6

Solder the wires to the appropriate spots on the new speaker, making sure that both wires are properly connected.
The wires may be hot.

Bewerken

Stap 7

Insert the new speaker into the hatch located in the middle part of the panel using a plastic spudger.
Make sure the speaker is the right size for the panel.
Once the speaker is properly placed, screw in the two 6.0 mm Philips J0 screws.
Do not over tighten the screws or the panel will break.