Inleiding

This is a step by step guide to removing the keyboard cover of an IBM ThinkPad 560z. The keyboard cover is most commonly removed to facilitate the cleaning or replacement of the keyboard.

  1. Remove the 7 mm Philip screws.
    • Remove the 7 mm Philip screws.

    • Remove the 10 mm Philip screws.

    • Remove the 14 mm Philip screw.

    Voeg opmerking toe

  2. Open the flap on the left hand side.
    • Open the flap on the left hand side.

    Voeg opmerking toe

    • Insert the iPod opening tools between the right and left sides of the latch.

    • Pry the right side of the latch, and then pry the left side to detach the laptop's cover.

    Voeg opmerking toe

    • Open the flap on the right side.

    Voeg opmerking toe

    • Insert the iPod opening tools towards the right side of the latch.

    • Gently pry the right side out to release the top cover.

    Voeg opmerking toe

    • Lift the keyboard slowly.

    • A cable connects the keyboard to the motherboard. If you are not careful, you will damage the cable.

    Voeg opmerking toe

    • Use your fingers or a spudger to detach the connector.

    Voeg opmerking toe

    • Carefully lift and remove the keyboard.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Derek Driscoll

Lid sinds: 15-04-10

119 Reputatie

8 handleidingen geschreven

Team

Cal Poly, Team 26-27, Regan Spring 2010 Lid van Cal Poly, Team 26-27, Regan Spring 2010

CPSU-REGAN-S10S26G27

3 Leden

18 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 1,498