Pry off back plastic, starting at the gap provided at the bottom of the phone. A spudger can be used to make this easier. Pry off back plastic, starting at the gap provided at the bottom of the phone. A spudger can be used to make this easier. Pry off back plastic, starting at the gap provided at the bottom of the phone. A spudger can be used to make this easier.
  • Pry off back plastic, starting at the gap provided at the bottom of the phone. A spudger can be used to make this easier.

Voeg opmerking toe

Remove battery, prying from the provided gap at the upper-right corner of the battery Remove battery, prying from the provided gap at the upper-right corner of the battery
  • Remove battery, prying from the provided gap at the upper-right corner of the battery

Voeg opmerking toe

Depress MicroSD to eject it from the side of the case. Depress MicroSD to eject it from the side of the case.
  • Depress MicroSD to eject it from the side of the case.

Voeg opmerking toe

Remove 4 corner screws, you may have to remove a "VOID" sticker from one of the screw heads. Remove 4 corner screws, you may have to remove a "VOID" sticker from one of the screw heads. Remove 4 corner screws, you may have to remove a "VOID" sticker from one of the screw heads.
  • Remove 4 corner screws, you may have to remove a "VOID" sticker from one of the screw heads.

Voeg opmerking toe

Using a spudger, unclip the nine clips holding the back panel to the front panel, highlighted in included pictures. Start at the top, and work clockwise, being careful not to break the clips. There are, 1, 3, 2, and 3 clips on each side, respectively.
  • Using a spudger, unclip the nine clips holding the back panel to the front panel, highlighted in included pictures.

  • Start at the top, and work clockwise, being careful not to break the clips.

  • There are, 1, 3, 2, and 3 clips on each side, respectively.

  • After the clips are disengaged, there are no cables holding the back panel in place.

Voeg opmerking toe

Use your spudger to release the remaining clips, disconnecting the ribbon cables from the logic board.
  • Use your spudger to release the remaining clips, disconnecting the ribbon cables from the logic board.

Voeg opmerking toe

Remove 2 Phillips Screws holding the logic board to the front panel. Gently lift the logic board off the front panel.
  • Remove 2 Phillips Screws holding the logic board to the front panel.

  • Gently lift the logic board off the front panel.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

6 andere personen hebben deze handleiding voltooid.

Mobile Rapid Response Unit

Lid sinds: 07-05-12

1.879 reputatie

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 5

Altijd: 3,821