Skip to main content

Inleiding

Step-by-step guide to removing your phone's back plate.

Onderdelen

Geen onderdelen opgegeven.

  1. Flip phone to see back cover. Using either finger or spugder tool press button located  near the top of phone by the antenna.
    • Flip phone to see back cover.

    • Using either finger or spugder tool press button located near the top of phone by the antenna.

  2. Pry up back plate from phone to reveal battery. Push button near bottom of battery using either your finger of the spudger.  This will release the battery.
    • Pry up back plate from phone to reveal battery.

    • Push button near bottom of battery using either your finger of the spudger. This will release the battery.

  3. MacBook-reparatiesets voor batterijen

    Vanaf $69.99

    Buy Now

    MacBook-reparatiesets voor batterijen

    Vanaf $69.99

    Buy Now
  4. Using a T6 Torx Screwdriver remove the four torxs on the back of the phone.
    • Using a T6 Torx Screwdriver remove the four torxs on the back of the phone.

  5. Simultaneously press indicated buttons on both sides of phone. Simultaneously press indicated buttons on both sides of phone.
    • Simultaneously press indicated buttons on both sides of phone.

  6. Separate back plate from the rest of phone.
    • Separate back plate from the rest of phone.

    • Make sure to not pull, there is a wire (circled on image) connecting the two plates.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Elizabeth OBrien

Lid sinds: 26-04-10

31 Reputatie

7 handleidingen geschreven

Team

Cal Poly, Team 30-40, Garner Spring 2010 Lid van Cal Poly, Team 30-40, Garner Spring 2010

CPSU-GARNER-S10S30G40

4 Leden

14 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 3

Afgelopen 30 Dagen: 6

Altijd: 3,198