Inleiding

After you remove the back cover, you can get to any part of your RoadMate.

Onderdelen

Geen onderdelen nodig.

Remove 4 rubber caps covering each screw by inserting the screwdriver into the side of cap and prying back and forth. Please note: this is a tedious process, but be patient.
  • Remove 4 rubber caps covering each screw by inserting the screwdriver into the side of cap and prying back and forth.

  • Please note: this is a tedious process, but be patient.

Voeg opmerking toe

Remove the 4 screws holding the cover in place using a Philips #00 screwdriver.
  • Remove the 4 screws holding the cover in place using a Philips #00 screwdriver.

Voeg opmerking toe

Open the back cover. Lift the cover slowly and carefully; the speaker is screwed on the back cover and is connected to the circuit board.
  • Open the back cover.

  • Lift the cover slowly and carefully; the speaker is screwed on the back cover and is connected to the circuit board.

Voeg opmerking toe

Disconnect the speaker from the terminal. When reassembling, make sure that you plug the terminal in the same way.  The black wire should be on the side farthest from the battery.
  • Disconnect the speaker from the terminal.

  • When reassembling, make sure that you plug the terminal in the same way. The black wire should be on the side farthest from the battery.

In my 1200, the speaker is glued to the back and soldered into the board so there is no plug to undo. Just carefully find a position so that board doesn't pull on the speaker wire while it is open.

Jomar - Antwoord

where can we get the speakers from? please

bbunni1404 - Antwoord

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Ross Light

Lid sinds: 12-04-10

175 reputatie

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 3,270