Inleiding

This guide will show how to remove the back cover.

Onderdelen

Geen onderdelen nodig.

  1. Remove the six external screws from the camera using a Phillips #0 screwdriver.
    • Remove the six external screws from the camera using a Phillips #0 screwdriver.

    • After the screws has been removed, the bottom of the back half of the external case should be loosened from the camera.

    • Be careful, make sure you don't lose the screws.

    Voeg opmerking toe

  2. Open the battery cover that's located on the bottom right side of the camera and carefully remove the battery.
    • Open the battery cover that's located on the bottom right side of the camera and carefully remove the battery.

    Voeg opmerking toe

    • Slide your fingernail or a plastic spudger in the groove from the bottom to the top right side of the camera.

    Voeg opmerking toe

    • Carefully squeeze the top right corner of the camera and pry off the external cover.

    • If you hear a "cracking" sound. This is normal.

    • Continue to pull the external cover and it will come off cleanly.

    • Be cautious of the flash capacitor. It carries an electrical charge, that may give you an unpleasant shock.

    Voeg opmerking toe

    • Carefully pull off the back cover, parts behind the back of the case might fall out.

    Voeg opmerking toe

Eindstreep

2 andere personen hebben deze handleiding voltooid.

Hasit

Lid sinds: 15-04-10

183 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 6-17, Maness Spring 2010 Lid van Cal Poly, Team 6-17, Maness Spring 2010

CPSU-MANESS-S10S6G17

4 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 2

Altijd: 3,312