Repareer je spullen Gemeenschap Winkel

Razer Naga Trinity LED Light Ribbon Cable Replacement

Inleiding

If the LED on the mouse will not illuminate, the LED light ribbon cable might be disconnected or might need to be replaced. Reasons that the LED light ribbon may be non-functional is that the mouse drive could be out of date, there could be a physical issue with the ribbon cable, or there could be a connection issue. This guide will list all required steps to properly replace the LED light ribbon cable from the Razer Naga Trinity.

Wat je nodig hebt

  1. Razer Naga Trinity LED Light Ribbon Cable Replacement, Razer Naga Trinity Disassembly: stap 1, afbeelding 1 van 2 Razer Naga Trinity LED Light Ribbon Cable Replacement, Razer Naga Trinity Disassembly: stap 1, afbeelding 2 van 2

    • Remove the interchangeable side plate.

    Vertaal

  2. Razer Naga Trinity LED Light Ribbon Cable Replacement: stap 2, afbeelding 1 van 2 Razer Naga Trinity LED Light Ribbon Cable Replacement: stap 2, afbeelding 2 van 2

    • Remove the mouse's feet using the opening pick.

    Vertaal

  3. Razer Naga Trinity LED Light Ribbon Cable Replacement: stap 3, afbeelding 1 van 1

    • Remove the four 6mm screws by using a JIS #1 screwdriver.

    Vertaal

  5. Razer Naga Trinity LED Light Ribbon Cable Replacement: stap 4, afbeelding 1 van 2 Razer Naga Trinity LED Light Ribbon Cable Replacement: stap 4, afbeelding 2 van 2

    • Separate the top mouse housing from the bottom mouse housing using the opening pick.

    • Be careful not to tug too hard on the ribbon connector.

    Vertaal

  6. Razer Naga Trinity LED Light Ribbon Cable Replacement: stap 5, afbeelding 1 van 1

    • Unlock the ribbon connector that is held down by the main board clips using the spudger's pointed end.

    Vertaal

  7. Razer Naga Trinity LED Light Ribbon Cable Replacement: stap 6, afbeelding 1 van 1

    • Remove the side housing using the opening pick.

    Vertaal

  8. Razer Naga Trinity LED Light Ribbon Cable Replacement: stap 7, afbeelding 1 van 2 Razer Naga Trinity LED Light Ribbon Cable Replacement: stap 7, afbeelding 2 van 2

    • Remove the top housing LED 3-Pin connector that is near the main board.

    Vertaal

  9. Razer Naga Trinity LED Light Ribbon Cable Replacement, LED Light Ribbon Cable: stap 8, afbeelding 1 van 2 Razer Naga Trinity LED Light Ribbon Cable Replacement, LED Light Ribbon Cable: stap 8, afbeelding 2 van 2

    • Using the flat end of a spudger, unlock the ribbon cable holding the clips.

    • Remove the ribbon cable.

    Vertaal
Conclusie

To reassemble your device, follow these instructions in reverse order.

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 4

Afgelopen 30 dagen: 17

Altijd: 1,503