Inleiding

This guide is applicable for any chip that is considered a star, flower, b.b. chip, and bull's-eye. It is not recommended for a spider crack (without air pocket), surface damage, or a regular crack.

Preparatory Steps

1) Purchase the Rain-X Windshield Repair Kit

2) Move the vehicle to a dry and covered space, aim for room temperature.

3) Wash and dry the windshield completely.

Gereedschap

Onderdelen

Geen onderdelen nodig.

  1. To remove excess glass, scrape over the surface of the chip with the included razor blade.
    • To remove excess glass, scrape over the surface of the chip with the included razor blade.

  2. Attach the  Rain-X applicator base to the windshield, with the center of the base directly above the chip.
    • Attach the Rain-X applicator base to the windshield, with the center of the base directly above the chip.

    • Cut the tip of the repair resin bottle using the razor blade.

    • To attach resin chamber, screw the chamber into the center ring of the applicator base.

    • Screw the resin chamber clockwise until it is in contact with the windshield.

    • Apply 3-6 drops of resin from the resin repair bottle into the resin chamber.

    • To add the pressure driver, screw the driver clockwise into the resin chamber.

    • Make sure to tighten almost all the way.

    • Make sure the pressure driver is in contact with the windshield.

    • Set timer for 4-6 minutes - Let the adhesive absorb into the chip for 4-6 minutes.

    • To determine if the repair resin has absorbed properly, look at the glass from a 45 degree angle.

    • After the 4-6 minutes end, unscrew the pressure driver, turning it counter clockwise. Remove it to release any trapped air.

    • Reinsert pressure driver by twisting clockwise.

    • This will discard any air remaining in the chip.

    • To check for remaining damage, look for a dark color to appear.

    • Leave to cure for 5-10 minutes.

    • Once finished curing, remove the resin chamber and the pressure driver by screwing counter clockwise.

    • Remove the applicator by using the tabs on the suction cups.

    • Clean off any excess adhesive from the windshield.

    • Cover the chip gently with a curing strip.

    • Move the car into direct sunlight and leave for 4-6 hours.

    • Remove the curing strip and enjoy.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Jeffrey Ritchie

Lid sinds: 26-10-18

265 Reputatie

1 Handleiding geschreven

Team

UC Davis, Team S1-G8, Bender Fall 2018 Lid van UC Davis, Team S1-G8, Bender Fall 2018

UCD-BENDER-F18S1G8

3 Leden

1 handleiding geschreven

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 3

Altijd: 44