Repareer je spullen Gemeenschap Winkel

RYOBI P422 Safety Trigger Spring Replacement

Inleiding

If your springs become damaged or weak from extended use, it's wise to replace them to ensure proper function. These springs may be under compression/ tension, so be wary when removing/ replacing these parts.

Wat je nodig hebt

  1. RYOBI P422 Safety Trigger Spring Replacement, Battery and Handle: stap 1, afbeelding 1 van 2 RYOBI P422 Safety Trigger Spring Replacement, Battery and Handle: stap 1, afbeelding 2 van 2

    • To remove the battery press down on the two buttons located on each side of the battery and pull away from the body of the grinder.

    • To remove the handle hold grinder with one hand and use the other hand to unscrew the handle with a counter-clockwise motion

    Bewerken

  2. RYOBI P422 Safety Trigger Spring Replacement, Safety Trigger Spring: stap 2, afbeelding 1 van 1

    • Lay grinder flat on its side so the screws are facing up

    Bewerken

  4. RYOBI P422 Safety Trigger Spring Replacement: stap 3, afbeelding 1 van 3 RYOBI P422 Safety Trigger Spring Replacement: stap 3, afbeelding 2 van 3 RYOBI P422 Safety Trigger Spring Replacement: stap 3, afbeelding 3 van 3

    • Remove the four 1.8 cm screws from the lower and midsection of the body with a T20-20 Torque screwdriver.

    • Remove the 3.7 cm screws from the upper section of the body, with the same screwdriver

    Bewerken

  5. RYOBI P422 Safety Trigger Spring Replacement: stap 4, afbeelding 1 van 3 RYOBI P422 Safety Trigger Spring Replacement: stap 4, afbeelding 2 van 3 RYOBI P422 Safety Trigger Spring Replacement: stap 4, afbeelding 3 van 3

    • Now that the two halves are unscrewed, remove the top half

    Bewerken

  6. RYOBI P422 Safety Trigger Spring Replacement: stap 5, afbeelding 1 van 3 RYOBI P422 Safety Trigger Spring Replacement: stap 5, afbeelding 2 van 3 RYOBI P422 Safety Trigger Spring Replacement: stap 5, afbeelding 3 van 3

    • Remove the safety trigger along with the spring.

    • To remove the spring, pull it gently off the bottom of the trigger.

    • When putting a new spring in make sure it slides into the grove on the bottom of the trigger.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

Auteur

met 3 andere bijdragers

Thomas Napert

Lid sinds: 03/16/15

279 Reputatie

2 handleidingen geschreven

Medailles: 11

+8 andere badges

Team

UMass Dartmouth, Team 3-6, Duarte Spring 2015 Lid van UMass Dartmouth, Team 3-6, Duarte Spring 2015

UMASSD-DUARTE-S15S3G6

3 Leden

5 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 2

Afgelopen 7 dagen: 6

Afgelopen 30 dagen: 19

Altijd: 1,502