Ga door naar hoofdinhoud

Protocol Galileo Stealth Housing Replacement

Wat je nodig hebt

  1. Protocol Galileo Stealth Housing Replacement, Propeller: stap 1, afbeelding 1 van 1
    • Remove the chrome shaft cover by lightly pulling it away from the drone.

  2. Protocol Galileo Stealth Housing Replacement: stap 2, afbeelding 1 van 1
    • Using a Phillips #000 screwdriver, remove the 7mm screw from the propeller stop.

    • Be sure to apply adequate pressure when removing the screw to prevent stripping it out.

  3. Protocol Galileo Stealth Housing Replacement: stap 3, afbeelding 1 van 1
    • Remove the propeller stop from shaft by lightly pulling it away from the drone.

  4. Protocol Galileo Stealth Housing Replacement: stap 4, afbeelding 1 van 1
    • Remove the propeller from shaft by lightly pulling it away from the drone.

  5. Protocol Galileo Stealth Housing Replacement, Housing: stap 5, afbeelding 1 van 2 Protocol Galileo Stealth Housing Replacement, Housing: stap 5, afbeelding 2 van 2
    • Remove the 8mm long Phillips #0 screws (24 total) from the lower housing unit.

    • Take care to place the screws in a safe place to prevent losing them.

  6. Protocol Galileo Stealth Housing Replacement: stap 6, afbeelding 1 van 1
    • Separate the upper and lower housing units by lightly pulling the two housing units apart.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Matthew Selting

Lid sinds: 02/15/18

432 Reputatie

4 handleidingen geschreven

Team

UW Stout, Team S8-G4, Ogden Spring 2018 Lid van UW Stout, Team S8-G4, Ogden Spring 2018

UWSTOUT-OGDEN-S18S8G4

4 Leden

6 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 6

Altijd: 130