Repareer je spullen Gemeenschap Winkel

Protocol Dronium Two Blade Guard Replacement

Inleiding

This guide shows how to remove the blade guard on the Protocol Dronium Two. The only tool you will need is the #0 Phillips screwdriver. The screwdriver is also included in the box of your drone. Perform this repair in a clean and well lit area so that you don't lose the screw.

Wat je nodig hebt

  1. Protocol Dronium Two Blade Guard Replacement, Blade Guard: stap 1, afbeelding 1 van 1

    • Turn the drone off by moving the selector switch to the left.

    Bewerken

  3. Protocol Dronium Two Blade Guard Replacement: stap 2, afbeelding 1 van 2 Protocol Dronium Two Blade Guard Replacement: stap 2, afbeelding 2 van 2

    • Using your screwdriver, remove the 8.36mm Phillips screw.

    Bewerken

  4. Protocol Dronium Two Blade Guard Replacement: stap 3, afbeelding 1 van 1

    • While holding the drone with one hand, gently lift the blade guard straight up and remove it.

    • Be careful not to break off the two studs holding the blade guard in place.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Auteur

met 2 andere bijdragers

Edwin Brietz

Lid sinds: 01/18/17

557 Reputatie

4 handleidingen geschreven

Medailles: 9

+6 andere badges

Team

Arkansas State University, Team 1-2, Chamberlain Spring 2017 Lid van Arkansas State University, Team 1-2, Chamberlain Spring 2017

ARSU-CHAMBERLAIN-S17S1G2

4 Leden

5 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 1

Altijd: 214