Ga door naar hoofdinhoud

Onderdelen

Geen onderdelen opgegeven.

  1. Use the flat end of a spudger to pry the sound card ribbon cable connector up off the logic board.
    • Use the flat end of a spudger to pry the sound card ribbon cable connector up off the logic board.

    • Move the sound card ribbon cable away from the face of the hard drive.

    • It is not necessary to disconnect the sound card ribbon cable from the sound card.

  2. Use the flat end of a spudger to pry the hard drive ribbon cable connector up off the logic board.
    • Use the flat end of a spudger to pry the hard drive ribbon cable connector up off the logic board.

  3. Remove the following four screws: Three 11.1 mm T8 Torx.
    • Remove the following four screws:

    • Three 11.1 mm T8 Torx.

    • One 3.9 mm T8 Torx.

    • Lift the hard drive out of the lower case.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 1,265