Inleiding

This guide shows the hidden screws you must remove when replacing the keyboard.

Use a coin to turn the battery locking screw 90 degrees to the right.
  • Use a coin to turn the battery locking screw 90 degrees to the right.

  • Lift the battery out of the computer.

Voeg opmerking toe

Remove the four Phillips screws from the memory door.
  • Remove the four Phillips screws from the memory door.

  • Slide the memory door away from the memory compartment.

Voeg opmerking toe

  • Remove the long black Phillips screw next to the memory card.

  • Remove the small EMI finger beneath the black screw.

Voeg opmerking toe

  • On the keyboard, remove the F1, F2, F11, and F12 keys.

  • This is scary - take a deep breath before continuing. Place your index finger under the upper left corner of the key and lift up until you hear a click. Then, transfer your finger to the left edge of the key and lift up to pull the key off.

  • You're freeing the two tabs on the left of the key from the two small holes in the plastic scissors mechanism.

  • When replacing the keys in the keyboard, place the key directly over the slot where it will go and press down until you hear the key click into place.

Voeg opmerking toe

  • Use your fingernail or a small flathead screwdriver to peel up the gray stickers covering each of the screws.

Voeg opmerking toe

  • Remove the two short Phillips screws.

Voeg opmerking toe

  • Lift the keyboard by the 'esc' and 'eject' keys and gently lift up until the keyboard is vertical.

Voeg opmerking toe

  • Grasp the keyboard connector ribbon near the connector and disconnect it from the logic board.

Pull straight up, not sideways. I used tweezers on the connector, rather than pulling on the ribbon cable.

vmile - Antwoord

mine had foil tape over the connector

Avi Fagan - Antwoord

Carefully lift edges of foil tape across logic board connector end of keyboard cable (foil is present if unit

has not been apart before).

Grasp cable near the connector and gently pull straight up (perpendicular to logic board).

John Haruguchi - Antwoord

Conclusie

To reassemble your device, follow these instructions in reverse order.

3 andere personen hebben deze handleiding voltooid.

Bijgevoegde documenten

iRobot

Lid sinds: 24-09-09

1 Reputatie

774 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 3

Afgelopen 30 Dagen: 12

Altijd: 14,069