Inleiding

Removing the CPU of the Power Mac G4 Quicksilver for replacement.

Onderdelen

Geen onderdelen nodig.

The handle to open your computer is located on top of the right side panel.
  • The handle to open your computer is located on top of the right side panel.

Voeg opmerking toe

Grab the circular handle and pull outward.
  • Grab the circular handle and pull outward.

Voeg opmerking toe

  • Your computer is now open and ready for repair.

Voeg opmerking toe

  • This is your Power Mac G4's video adapter.

Voeg opmerking toe

  • Start by removing the screw holding the card to the chassis as shown.

Voeg opmerking toe

  • Before lifting the card out, this small plastic tab needs to be pulled back there by releasing it entirely.

Voeg opmerking toe

  • With the tab and screw removed, lift the card straight out.

  • When putting the card back in, take care to apply even pressure across the top with your thumbs. This will avoid damaging the card.

Voeg opmerking toe

  • First you want to remove the fan. Remove the two screws on the back of the computer in the upper left hand corner.

Voeg opmerking toe

  • Remove the fan unit by pulling straight up and out.

  • Be carful not to rip out the cord still attached to the motherboard. Remove it gently.

Voeg opmerking toe

  • You need detach the heat sink from the CPU. Locate the four clamps holding it down, two on each side.

  • Taking off the clamps can be difficult. Use a screwdriver to push down on the top of the clip. Then insert a spudger below the heat sink to pull it away from the board, releasing the heat sink.

Voeg opmerking toe

  • Pull the heat sink up and off of the CPU.

Voeg opmerking toe

  • Remove the four screws holding the CPU to the motherboard.

Voeg opmerking toe

  • Now you can remove the CPU by pulling it straight up from the motherboard.

  • Be very careful when you detach the CPU. There is a connector that has hundreds of little prongs. You must not bend or break any of them! Be extremely careful.

Voeg opmerking toe

  • You can now replace the CPU.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

9 andere personen hebben deze handleiding voltooid.

Ryan Bylard

Lid sinds: 20-01-10

1.230 Reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 14-41, Regan Winter 2010 Lid van Cal Poly, Team 14-41, Regan Winter 2010

CPSU-REGAN-W10S14G41

4 Leden

10 handleidingen geschreven

Één commentaar

Removing graphics (video) card is not necessary. Also, removing the clips which retain heat-sink can be accomplished by using a flat-blade (-) screwdriver to carefully pry them from the finned aluminum assembly. Other than these two suggestions, guide is succinct and accurate.

analogcd - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 4

Afgelopen 30 Dagen: 17

Altijd: 9,601