Ga door naar hoofdinhoud

Deze handleiding heeft recentere wijzigingen. Schakel over naar de nieuwste niet-geverifieerde versie.

PlayStation 3 Slim Motherboard Assembly Replacement

Alleen vereisten
Deze handleiding is alleen bedoeld als vereiste voor andere handleidingen. Het staat niet op zichzelf.

Wat je nodig hebt

  1. PlayStation 3 Slim Motherboard Assembly Replacement, Motherboard Assembly: stap 1, afbeelding 1 van 1
    • Pull the AC-In cables upward to remove the AC inlet from the lower case.

  2. PlayStation 3 Slim Motherboard Assembly Replacement: stap 2, afbeelding 1 van 2 PlayStation 3 Slim Motherboard Assembly Replacement: stap 2, afbeelding 2 van 2
    • Use the flat end of a spudger to pry both antenna connectors up from their sockets on the motherboard.

  3. PlayStation 3 Slim Motherboard Assembly Replacement: stap 3, afbeelding 1 van 1
    • Pull the control board ribbon cable up and out of its socket on the motherboard.

    • Remove the control board.

  4. PlayStation 3 Slim Motherboard Assembly Replacement: stap 4, afbeelding 1 van 1
    • Turn the PS3 over and lay it on its backside.

    • Use the flat edge of a metal spudger to pop up the small access door on the bottom cover near the front of the PS3.

    • Remove the blue Phillips screw hidden under the access door.

  5. PlayStation 3 Slim Motherboard Assembly Replacement: stap 5, afbeelding 1 van 1
    • Slide the hard drive bay cover toward the right side of the lower case, then pull it away from the front edge to remove it from the PS3.

  6. PlayStation 3 Slim Motherboard Assembly Replacement: stap 6, afbeelding 1 van 1
    • Using its attached metal handle, pull the hard drive out of its bay.

  7. PlayStation 3 Slim Motherboard Assembly Replacement: stap 7, afbeelding 1 van 1
    • Remove the following five screws securing the motherboard assembly to the lower case:

    • Two silver 6 mm Phillips

    • Three black 8 mm Phillips

  8. PlayStation 3 Slim Motherboard Assembly Replacement: stap 8, afbeelding 1 van 1
    • Lift the motherboard assembly from its front edge and remove it from the lower case, minding the antenna cable still attached to the lower case.

    • Be careful not to bend the metal antenna bodies as you lift the motherboard assembly.

Conclusie

To reassemble your device, follow these instructions in reverse order.

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 1

Afgelopen 7 dagen: 6

Afgelopen 30 dagen: 10

Altijd: 1,192