Ga door naar hoofdinhoud

PlayStation 2 Slimline IR Sensor Replacement

Wat je nodig hebt

  1. PlayStation 2 Slimline IR Sensor Replacement, Outer Shell: stap 1, afbeelding 1 van 1
    • Disconnect all cables from the console and flip the unit over to reveal its base.

  2. PlayStation 2 Slimline IR Sensor Replacement: stap 2, afbeelding 1 van 3 PlayStation 2 Slimline IR Sensor Replacement: stap 2, afbeelding 2 van 3 PlayStation 2 Slimline IR Sensor Replacement: stap 2, afbeelding 3 van 3
    • Locate the 6 feet on the base of the unit. Pry them off using a spudger to reveal the screws.

    • Note: One of the feet is located under the sticker shown in the photo. Removing this sticker will void any warranty with Sony.

  3. PlayStation 2 Slimline IR Sensor Replacement: stap 3, afbeelding 1 van 3 PlayStation 2 Slimline IR Sensor Replacement: stap 3, afbeelding 2 van 3 PlayStation 2 Slimline IR Sensor Replacement: stap 3, afbeelding 3 van 3
    • Remove all six 4.0 mm screws from the base of the unit using a #1 Phillips screwdriver.

  4. PlayStation 2 Slimline IR Sensor Replacement: stap 4, afbeelding 1 van 3 PlayStation 2 Slimline IR Sensor Replacement: stap 4, afbeelding 2 van 3 PlayStation 2 Slimline IR Sensor Replacement: stap 4, afbeelding 3 van 3
    • Starting at the corner at which the power and Ethernet ports are located, pry open the outer shell using a spudger and continue around the entire unit.

    • Note: You may use your hands for additional force to separate the two pieces of the outer shell.

  5. PlayStation 2 Slimline IR Sensor Replacement, IR Sensor: stap 5, afbeelding 1 van 1
    • Locate the IR sensor at the front, right corner of the unit.

  6. PlayStation 2 Slimline IR Sensor Replacement: stap 6, afbeelding 1 van 1
    • Gently detach the ribbon cable connecting the IR sensor to the motherboard.

    • Caution: Always remove ribbon cables by the plastic handles located on either end. Gripping a ribbon cable anywhere but the provided handles can damage the cable and render the component useless.

  7. PlayStation 2 Slimline IR Sensor Replacement: stap 7, afbeelding 1 van 1
    • Gently lift and remove the IR Sensor from its designated slot.

Conclusie

To reassemble your device, follow these instructions in reverse order.

7 andere personen hebben deze handleiding voltooid.

Thomas Sullivan

Lid sinds: 10/23/13

3.900 Reputatie

6 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 5

Afgelopen 7 dagen: 14

Afgelopen 30 dagen: 75

Altijd: 6,736