Ga door naar hoofdinhoud

Inleiding

This guide will show you the steps to remove the headband.

Onderdelen

Geen onderdelen opgegeven.

  1. Remove the two screws on the underside of the headband with the PH0 Phillips screw driver. Remove the two screws on the underside of the headband with the PH0 Phillips screw driver.
    • Remove the two screws on the underside of the headband with the PH0 Phillips screw driver.

  2. With the headband fully extended, hold the base of the headband with one hand and with your other hand, hold the top of the headband. With force, pull upwards.
    • With the headband fully extended, hold the base of the headband with one hand and with your other hand, hold the top of the headband.

    • With force, pull upwards.

  3. Remove the rail-piece that is now sticking up by pulling it up and out of the headphone. Repeat on the opposite side and the headband will be released. During reassembly, make the sure the rail-pieces match their respective sides so the headband reinserts properly.
    • Remove the rail-piece that is now sticking up by pulling it up and out of the headphone.

    • Repeat on the opposite side and the headband will be released.

    • During reassembly, make the sure the rail-pieces match their respective sides so the headband reinserts properly.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Garrett Leung

Lid sinds: 16-04-13

886 Reputatie

8 handleidingen geschreven

Team

Cal Poly, Team 10-40, Amido Spring 2013 Lid van Cal Poly, Team 10-40, Amido Spring 2013

CPSU-AMIDO-S13S10G40

4 Leden

20 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 2

Afgelopen 30 dagen: 9

Altijd: 594