Repareer je spullen Gemeenschap Winkel

Pentax PZ-10 Back Cover Locking Switch Spring Replacement

Inleiding

If the back cover of the Pentax PZ-10 won't lock in place, the spring that holds the door in place may need to be replaced.

Wat je nodig hebt

  1. Pentax PZ-10 Back Cover Locking Switch Spring Replacement, Removing the Bottom Cover: stap 1, afbeelding 1 van 1

    • With the lens face up and the bottom panel of the camera facing you, remove the two 7mm screws on the left using the J0 screwdriver.

    • Remove the six 4.3mm screws in the middle and right of the panel using the J0 screwdriver.

    • Pull off the bottom casing to remove.

    Bewerken

  2. Pentax PZ-10 Back Cover Locking Switch Spring Replacement, Removing Bottom Casing: stap 2, afbeelding 1 van 1

    • With the screws removed, the bottom casing should come off very easily by pulling on the casing.

    Bewerken

  3. Pentax PZ-10 Back Cover Locking Switch Spring Replacement, Removing the Back Cover: stap 3, afbeelding 1 van 1

    • Place the camera on its side so the lens is facing left.

    • Press down on the locking switch on the side panel facing you.

    Bewerken

  5. Pentax PZ-10 Back Cover Locking Switch Spring Replacement: stap 4, afbeelding 1 van 1

    • With the door unlocked, rotate the device to access the bottom.

    Bewerken

  6. Pentax PZ-10 Back Cover Locking Switch Spring Replacement: stap 5, afbeelding 1 van 1

    • Using a pair of tweezers, gently remove the metal tab securing the back door axle.

    • The door will come loose at this point, watch for any loose parts that may also come out.

    Bewerken

  7. Pentax PZ-10 Back Cover Locking Switch Spring Replacement, Removing the Side Panel: stap 6, afbeelding 1 van 1

    • Once the back cover is fully removed, remove the two 4.35mm screws attaching the cover of the unlocking switch, and remove the plate.

    Bewerken

  8. Pentax PZ-10 Back Cover Locking Switch Spring Replacement, Removing the Spring: stap 7, afbeelding 1 van 1

    • Locate the spring at the upper left corner of the face, and pull the rings of the spring off of the pins to remove it using plastic opening tools.

    • You are now ready to replace the spring.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Auteur

met 5 andere bijdragers

Ryan Su

Lid sinds: 04/20/15

107 Reputatie

1 Handleiding geschreven

Medailles: 6

+3 andere badges

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 1

Afgelopen 30 dagen: 2

Altijd: 414