Ga door naar hoofdinhoud

Pentax Optio WP Motherboard and Flash Unit Replacement

Alleen vereisten
Deze handleiding is alleen bedoeld als vereiste voor andere handleidingen. Het staat niet op zichzelf.

Wat je nodig hebt

  1. Pentax Optio WP Motherboard and Flash Unit Replacement, Motherboard and Flash Unit: stap 1, afbeelding 1 van 1
    • Remove the 4 mm black screw on the bottom right corner of the mother board.

    • The black screw may be hard to remove. Use the tweezers if necessary.

  2. Pentax Optio WP Motherboard and Flash Unit Replacement: stap 2, afbeelding 1 van 1
    • With the tweezers, carefully peel back the copper ribbon that was underneath the black screw.

  3. Pentax Optio WP Motherboard and Flash Unit Replacement: stap 3, afbeelding 1 van 1
    • Remove the 2.5 mm silver screw from the upper left corner of the motherboard.

  4. Pentax Optio WP Motherboard and Flash Unit Replacement: stap 4, afbeelding 1 van 2 Pentax Optio WP Motherboard and Flash Unit Replacement: stap 4, afbeelding 2 van 2
    • Press down on the metal plate and gently lift the motherboard up from left to right.

    • Be cautious when lifting the motherboard since there is a copper ribbon and two wires attaching the motherboard to the flash unit.

    • Reorient the camera so you are looking at the top edge with the metal plate on the right.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Derek

Lid sinds: 01/21/11

746 Reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 1-13, Amido Winter 2011 Lid van Cal Poly, Team 1-13, Amido Winter 2011

CPSU-AMIDO-W11S1G13

5 Leden

18 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 236