Inleiding

Directions are given as if you were holding the camera to take a picture.

Onderdelen

Geen onderdelen nodig.

  1. Locate the memory card and battery card latch on the bottom of the camera.
    • Locate the memory card and battery card latch on the bottom of the camera.

    • Slide the latch to the open position.

    Voeg opmerking toe

  2. Open the battery latch, and slide the battery release lever to the right.
    • Open the battery latch, and slide the battery release lever to the right.

    Voeg opmerking toe

    • Remove the battery from the camera.

    Voeg opmerking toe

    • Using a size #00 Phillips screwdriver, remove the three 4.58 mm screws on the bottom of the camera.

    • Use this screwdriver for all screws in the device.

    Voeg opmerking toe

    • Remove the 3.15 mm screw on the left side of the camera.

    Voeg opmerking toe

    • Remove the left side casing.

    Voeg opmerking toe

    • Remove the two 3.15 mm screws on the right side of the camera.

    Voeg opmerking toe

    • Remove the bottom right panel.

    Voeg opmerking toe

    • Gently remove the back casing.

    • Start at the bottom and carefully pry towards the top to get this piece free.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Andrew

Lid sinds: 11-10-10

381 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 9-22, Regan Fall 2010 Lid van Cal Poly, Team 9-22, Regan Fall 2010

CPSU-REGAN-F10S9G22

4 Leden

8 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 7

Altijd: 3,058