Inleiding

How remove the outer casing

Onderdelen

Geen onderdelen nodig.

  1. Lay device face down on surface.
    • Lay device face down on surface.

  2. Heat the left and top edges with hairdryer for one minute. Move hairdryer back and forth to evenly heat up surface.
    • Heat the left and top edges with hairdryer for one minute.

    • Move hairdryer back and forth to evenly heat up surface.

    • Caution: directly heating the screen can melt or distort the screen.

  3. Gratis verzending van alle bestellingen van meer dan US$ 100,00 of met een Pro Tech Toolkit!

    Doorblader onze winkel

    Ooit iets gerepareerd? Je bent een genie.

    Deel je reparatie met #ImAGenius

    We zijn allemaal genieën

    Deel je reparatie met #ImAGenius

  4. Use tweezers to hold Palm right side down on it's side.
    • Use tweezers to hold Palm right side down on it's side.

    • Use a plastic opening tool to pry open front and back casing.

    • If you are unable to open you may need to heat with hairdryer for longer.

    • Be sure not to touch case directly with fingers, it will be hot!

  5. Leave plastic opening tools in between front and back casing.
    • Leave plastic opening tools in between front and back casing.

    • Rotate Palm and repeat steps 2 and 3 for right and back edges.

  6. Now pry open front and back casing with plastic opening tools. Separate front and back casing completely. Power button will fall off once front and back casing have been removed. Be sure not to lose it.
    • Now pry open front and back casing with plastic opening tools.

    • Separate front and back casing completely.

    • Power button will fall off once front and back casing have been removed. Be sure not to lose it.

Eindstreep

Anthony Platt

Lid sinds: 09-02-10

66 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 13-25, Maness Winter 2010 Lid van Cal Poly, Team 13-25, Maness Winter 2010

CPSU-MANESS-W10S13G25

4 Leden

4 handleidingen geschreven

Één commentaar

So...This given by my grandmother and it is out of battery. Unluckily, it won't charge, because the %#*@ old battery had gone kaput. I had a hard time finding one that might be suitable, and turnout that I need to insert it into the device and connect it to the circuit board. I have some solid soldering skills, but without a heat gun, the andonized cover won't come off. And what's more, I jammed a pencil tip into the "reset" hole when trying to reset the device. Thinking the big opening was a kind of cover-releasing button...I was just having a whole lot of trouble and thinking too much. !&&*.

Xavier Jiang - Antwoord

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 1,354