Inleiding

This guide will provide instructions and visuals on how to replace the display screen.

Onderdelen

Geen onderdelen nodig.

Remove the batteries.
  • Remove the batteries.

Voeg opmerking toe

Using a Torx 5 screwdriver, remove the four screws located on the rear cover of the device by turning counterclockwise. Set aside screws.
  • Using a Torx 5 screwdriver, remove the four screws located on the rear cover of the device by turning counterclockwise. Set aside screws.

Voeg opmerking toe

Remove rear cover by gently lifting it up from the bottom.
  • Remove rear cover by gently lifting it up from the bottom.

Voeg opmerking toe

Carefully lift up the circuit board, which will also lift up the screen. Do so carefully to prevent breaking the connectors.
  • Carefully lift up the circuit board, which will also lift up the screen. Do so carefully to prevent breaking the connectors.

Voeg opmerking toe

  • Lift the left side of the circuit board and open it as though it were a book.

Voeg opmerking toe

Unplug the three connectors located on the right side of the circuit board with great caution and care. Do not pull by the cable, and be sure to pull the connector itself gently.
  • Unplug the three connectors located on the right side of the circuit board with great caution and care. Do not pull by the cable, and be sure to pull the connector itself gently.

Voeg opmerking toe

  • After separating the screen from the board, set aside the old display screen.

Voeg opmerking toe

  • Replace with a new display screen.

Voeg opmerking toe

Plug in the three connectors.
  • Plug in the three connectors.

Voeg opmerking toe

Close again like a book, and lay it gently into the front panel, screen facing outwards of the front panel.
  • Close again like a book, and lay it gently into the front panel, screen facing outwards of the front panel.

Voeg opmerking toe

Put the back cover on the device and screw the four screws, screwing in a clockwise direction.  Take caution not to over-tighten the screws.
  • Put the back cover on the device and screw the four screws, screwing in a clockwise direction. Take caution not to over-tighten the screws.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Lexi Gallucci

Lid sinds: 18-10-11

11 reputatie

2 handleidingen geschreven

Team

James Madison, Team 1-3, Allen Fall 2011 Lid van James Madison, Team 1-3, Allen Fall 2011

JMU-ALLEN-F11S1G3

5 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 2

Altijd: 489