Inleiding

This guide will help you access and replace the Treo's camera if it is no longer functional.

Position the phone so the screen faces down.
  • Position the phone so the screen faces down.

  • Remove the stylus found on the back of the phone.

Voeg opmerking toe

To remove the battery cover, hold down the button in the middle of the phone's back.
  • To remove the battery cover, hold down the button in the middle of the phone's back.

  • Slide the cover down to remove. Set the cover aside.

Voeg opmerking toe

Lift the edge of the battery, separating contact points, and pull out as pictured. Lift the edge of the battery, separating contact points, and pull out as pictured.
  • Lift the edge of the battery, separating contact points, and pull out as pictured.

Voeg opmerking toe

Remove the small round rubber cover on the back of the phone located immediately below the antenna.
  • Remove the small round rubber cover on the back of the phone located immediately below the antenna.

  • This will uncover a screw that will be removed in the next step.

Voeg opmerking toe

MacBook Battery Fix Kits
Fix Kits Starting at $69.99
MacBook Battery Fix Kits
Starting at $69.99
Unscrew six black 6.9 mm Torx screws with a T5 Torx Screwdriver. Unscrew one 9.75 mm Phillips antenna screw with a Phillips #00 Screwdriver. Pull out antenna.
  • Unscrew six black 6.9 mm Torx screws with a T5 Torx Screwdriver.

  • Unscrew one 9.75 mm Phillips antenna screw with a Phillips #00 Screwdriver.

  • Pull out antenna.

Voeg opmerking toe

Pry the back cover off using a spudger or similar tool. The back cover is attached by several small clips on the inside.
  • Pry the back cover off using a spudger or similar tool.

  • The back cover is attached by several small clips on the inside.

Voeg opmerking toe

Remove the two 3.75 mm screws. Pull off the logic board. Pull off the logic board.
  • Remove the two 3.75 mm screws.

  • Pull off the logic board.

Voeg opmerking toe

Pull the rubber ring off of the camera. Pull the rubber ring off of the camera. Pull the rubber ring off of the camera.
  • Pull the rubber ring off of the camera.

Voeg opmerking toe

Pry off the metal camera case. Lift up the camera, but do not remove. The connector must be detatched first.
  • Pry off the metal camera case.

  • Lift up the camera, but do not remove. The connector must be detatched first.

Voeg opmerking toe

Pry off the camera connector plug. Remove the camera.
  • Pry off the camera connector plug.

  • Remove the camera.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

cgood

Lid sinds: 28-10-09

116 reputatie

14 handleidingen geschreven

Team

Cal Poly, Team 19-3, Maness Fall 2009 Lid van Cal Poly, Team 19-3, Maness Fall 2009

CPSU-MANESS-F09S19G3

4 Leden

18 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 4

Altijd: 1,951