Inleiding

Guide for removing the Analog stick in a Sony PSP-3000

Place the PSP face down and locate the battery cover on the left side of the device. Lift and remove the battery cover to reveal the battery. Remove the battery.
  • Place the PSP face down and locate the battery cover on the left side of the device.

  • Lift and remove the battery cover to reveal the battery.

  • Remove the battery.

Voeg opmerking toe

Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.
  • Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.

Voeg opmerking toe

Unscrew all four screws from the back of the PSP with the Phillips #00 Screwdriver. Two are located behind the battery's warranty sticker.
  • Unscrew all four screws from the back of the PSP with the Phillips #00 Screwdriver.

    • Two are located behind the battery's warranty sticker.

    • Two are located on the right side of the PSP.

Voeg opmerking toe

Next, unscrew the two screws located at the top of the PSP.
  • Next, unscrew the two screws located at the top of the PSP.

Voeg opmerking toe

Then, remove the single screw from the bottom edge of the PSP (which is positioned next to the barcode).
  • Then, remove the single screw from the bottom edge of the PSP (which is positioned next to the barcode).

Voeg opmerking toe

Slide the spudger in between the outer casing of the PSP, beginning at the "R" shoulder button, and gently pry off the casing.
 Remove the front casing completely.
  • Slide the spudger in between the outer casing of the PSP, beginning at the "R" shoulder button, and gently pry off the casing.


  • Remove the front casing completely.

Voeg opmerking toe

Push the homebar to the right to release the tab located on the right side of the LCD screen.
  • Push the homebar to the right to release the tab located on the right side of the LCD screen.

  • DO NOT completely remove the homebar, as it is still connected by ribbon cables.

Voeg opmerking toe

Slowly lift the LCD screen off the PSP starting at the top edge corner. Again, the LCD screen is attached by ribbon cables, so do not remove it completely.
  • Slowly lift the LCD screen off the PSP starting at the top edge corner.

  • Again, the LCD screen is attached by ribbon cables, so do not remove it completely.

    • Orientation of PSP is flipped in photo.

Voeg opmerking toe

Geschenkgids voor Vaderdag
Laten we niet enkel onze vaders vieren, maar ook alle mentors die ons hebben leren repareren.
Geschenkgids voor Vaderdag
Laten we iedereen vieren die ons heeft lereren repareren.
Flip the small brown locks on the four ribbon cable connectors up using a spudger or fingernail. Pull all four ribbon cables out.
  • Flip the small brown locks on the four ribbon cable connectors up using a spudger or fingernail.

  • Pull all four ribbon cables out.

  • Now remove the LCD screen and homebar from the PSP.

Voeg opmerking toe

Remove the metal tab that lies above the LCD screen.
  • Remove the metal tab that lies above the LCD screen.

  • Upon reassembly, make note that the stamped lettering faces down, and the large tab fits just above the motherboard to the right hand side of the left trigger.

Voeg opmerking toe

Remove the screw securing 'L' trigger to the PSP.
  • Remove the screw securing 'L' trigger to the PSP.

Voeg opmerking toe

Remove the white plastic piece that holds the 'L' trigger in place.
  • Remove the white plastic piece that holds the 'L' trigger in place.

Voeg opmerking toe

Remove the 'L' trigger from the PSP.
  • Remove the 'L' trigger from the PSP.

Voeg opmerking toe

Remove the screw securing the 'R' trigger.
  • Remove the screw securing the 'R' trigger.

Voeg opmerking toe

Remove the white plastic piece that holds the 'R' trigger in place.
  • Remove the white plastic piece that holds the 'R' trigger in place.

Voeg opmerking toe

Remove the 'R' trigger from the PSP.
  • Remove the 'R' trigger from the PSP.

Voeg opmerking toe

Remove the screw from the bottom left edge of the PSP.
  • Remove the screw from the bottom left edge of the PSP.

Voeg opmerking toe

Being careful not to break the ribbon cable, use the spudger to peel the adhesive button of the the 'L' trigger off the PSP.
  • Being careful not to break the ribbon cable, use the spudger to peel the adhesive button of the the 'L' trigger off the PSP.

Being careful not to break the ribbon cable, use the spudger to peel the adhesive button of the 'L' trigger off the PSP.

buzinon - Antwoord

Using a fingernail or spudger, flip up the retaining bracket on the d-pad and 'L' trigger ribbon cable. Lift the black plastic bracket along with the d-pad contact pad, disconnecting the ribbon cable as you lift.
  • Using a fingernail or spudger, flip up the retaining bracket on the d-pad and 'L' trigger ribbon cable.

  • Lift the black plastic bracket along with the d-pad contact pad, disconnecting the ribbon cable as you lift.

Voeg opmerking toe

Remove the cable from the connector and remove the entire black piece from the PSP.
  • Remove the cable from the connector and remove the entire black piece from the PSP.

Voeg opmerking toe

Remove the screw holding the analog stick in place.
  • Remove the screw holding the analog stick in place.

Voeg opmerking toe

Flip up the lock on the analog sticks ribbon cable. Remove the analog stick from the PSP.
  • Flip up the lock on the analog sticks ribbon cable.

  • Remove the analog stick from the PSP.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

11 andere personen hebben deze handleiding voltooid.

mbnewsom

Lid sinds: 28-10-09

2.331 Reputatie

11 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 6

Afgelopen 7 Dagen: 27

Afgelopen 30 Dagen: 183

Altijd: 16,662