Inleiding

This guide would be useful in the event of a broken, scratched, or cracked lens.

  1. Pull the slider labeled open, on the bottom right, to unlock the battery. Pull the slider labeled open, on the bottom right, to unlock the battery.
    • Pull the slider labeled open, on the bottom right, to unlock the battery.

  2. Pull battery out of slot.
    • Pull battery out of slot.

  3. Remove the three screws (length 7.7 mm) from the bottom of the outer case using a JIS000 screwdriver.
    • Remove the three screws (length 7.7 mm) from the bottom of the outer case using a JIS000 screwdriver.

  4. Gratis verzending van alle bestellingen van meer dan US$ 100 of met een Pro Tech Toolkit!

    Doorblader onze winkel
  5. Remove plastic casing hiding screws from the strap side of the casing. Unscrew the three screws (length 4.75 mm)  using a PH000 screwdriver.
    • Remove plastic casing hiding screws from the strap side of the casing.

    • Unscrew the three screws (length 4.75 mm) using a PH000 screwdriver.

    • Unscrew the two screws (length 6.4 mm) using a JIS000 screwdriver.

  6. Unscrew the four screws (2.9 mm length) from the screen side of the casing using a JIS000 screwdriver.
    • Unscrew the four screws (2.9 mm length) from the screen side of the casing using a JIS000 screwdriver.

  7. Remove both side casings by gripping the sides with your hands and pulling gently.
    • Remove both side casings by gripping the sides with your hands and pulling gently.

  8. Although it requires extra steps, it is advised that you remove the motherboard and screen to ensure that nothing is damaged in the process of replacing the lens. Unscrew the seven screws (length 4.22 mm) from the motherboard using a PH000 screwdriver. Pull out or desolder all connected cords from motherboard.
    • Although it requires extra steps, it is advised that you remove the motherboard and screen to ensure that nothing is damaged in the process of replacing the lens.

    • Unscrew the seven screws (length 4.22 mm) from the motherboard using a PH000 screwdriver.

    • Pull out or desolder all connected cords from motherboard.

  9. Remove top of the casing to reveal the screws on lens. Unscrew the four screws (size 4.90 mm)  using a PH00 screwdriver.
    • Remove top of the casing to reveal the screws on lens.

    • Unscrew the four screws (size 4.90 mm) using a PH00 screwdriver.

  10. Pull out lens. Remove cord from lens. Remove cord from lens.
    • Pull out lens.

    • Remove cord from lens.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Nathan Mcintyre

Lid sinds: 05-11-18

303 Reputatie

2 handleidingen geschreven

Team

IUPUI, Team S1-G3, Baechle Fall 2018 Lid van IUPUI, Team S1-G3, Baechle Fall 2018

IUPUI-BAECHLE-F18S1G3

3 Leden

3 handleidingen geschreven

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 3

Altijd: 67