Inleiding

The guide shows how to remove the backplate of the camera. It is a prerequisite to other guides such as replacing the mic, speaker, LCD screen, and lens.

Flip camera so you are looking at the bottom.
  • Flip camera so you are looking at the bottom.

  • Unscrew all 5 base plate screws.

Voeg opmerking toe

Lift open retainer clip by sliding the clip to the left and letting the clip pop up.
  • Lift open retainer clip by sliding the clip to the left and letting the clip pop up.

Voeg opmerking toe

Unscrew the single screw located next to the battery slot.
  • Unscrew the single screw located next to the battery slot.

Voeg opmerking toe

Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.
  • Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.

  • Lift the rubber plate exposing the ports beneath.

Voeg opmerking toe

Unscrew the 2 screws next to the USB and AC ports.
  • Unscrew the 2 screws next to the USB and AC ports.

Voeg opmerking toe

Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.
  • Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.

Voeg opmerking toe

Pull off the faceplate to reveal the inside of the camera.
  • Pull off the faceplate to reveal the inside of the camera.

  • Be careful of the connector that goes from the faceplate to the motherboard . Disconnecting this line will cause the camera not not power on through the on/off switch anymore.

Voeg opmerking toe

Use a phillips head screwdriver to remove the 3 screws highlighted in the picture.
  • Use a phillips head screwdriver to remove the 3 screws highlighted in the picture.

Voeg opmerking toe

Unscrew the 2 screws located on either side of the flash.
  • Unscrew the 2 screws located on either side of the flash.

Voeg opmerking toe

Get a flathead screwdriver or an iPod opening tool (both are shown in this picture).
  • Get a flathead screwdriver or an iPod opening tool (both are shown in this picture).

  • Carefully pry off the blackplate from the remaining part of the camera.

Voeg opmerking toe

Pull the backplate off.
  • Pull the backplate off.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Katie

Lid sinds: 15-04-10

25 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 28-23, Regan Spring 2010 Lid van Cal Poly, Team 28-23, Regan Spring 2010

CPSU-REGAN-S10S28G23

4 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 1,933