Ga door naar hoofdinhoud

ORFELD EV-660-S222 Power Button Spring Replacement

Wat je nodig hebt

  1. ORFELD EV-660-S222 Power Button Spring Replacement, Power Button Spring: stap 1, afbeelding 1 van 1
    • Separate the dust cover and the motor from the vacuum body by pressing the eject button.

  2. ORFELD EV-660-S222 Power Button Spring Replacement: stap 2, afbeelding 1 van 2 ORFELD EV-660-S222 Power Button Spring Replacement: stap 2, afbeelding 2 van 2
    • Place the vacuum on its side, with the screws facing towards you.

    • Remove the 11.5 mm screws using a Phillips #1 screwdriver.

  3. ORFELD EV-660-S222 Power Button Spring Replacement: stap 3, afbeelding 1 van 2 ORFELD EV-660-S222 Power Button Spring Replacement: stap 3, afbeelding 2 van 2
    Gereedschap gebruikt in deze stap:
    Tweezers
    $4.99
    Koop
    • Using tweezers, remove the sticker connecting the two halves.

    • Use the opening pick to gently separate the top half and the bottom half of the vacuum.

    • Press the blue buttons near the sides of the battery LEDs to remove the top half.

  4. ORFELD EV-660-S222 Power Button Spring Replacement: stap 4, afbeelding 1 van 1
    • Lift the battery slightly to reveal the pin connectors.

    • Gently disconnect the six-pin connector from the battery.

  5. ORFELD EV-660-S222 Power Button Spring Replacement: stap 5, afbeelding 1 van 3 ORFELD EV-660-S222 Power Button Spring Replacement: stap 5, afbeelding 2 van 3 ORFELD EV-660-S222 Power Button Spring Replacement: stap 5, afbeelding 3 van 3
    • Gently pull out the power button from the board.

    • Gently pull up and twist the old spring off of the button.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Emma Lucas

Lid sinds: 09/26/22

241 Reputatie

2 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 1

Afgelopen 30 dagen: 2

Altijd: 63