Inleiding

Make sure device is unplugged.

Remove slip mat from top of the platter.
  • Remove slip mat from top of the platter.

Voeg opmerking toe

Remove platter by inserting thumbs in holes and slowly pulling up.
  • Remove platter by inserting thumbs in holes and slowly pulling up.

  • There will be some initial resistance.

Voeg opmerking toe

Remove damaged belt which will be located below the platter.
  • Remove damaged belt which will be located below the platter.

Voeg opmerking toe

Install new belt by securing it around the inner ring, located on the back of the platter.
  • Install new belt by securing it around the inner ring, located on the back of the platter.

Voeg opmerking toe

Place a thumb in each hole.
  • Place a thumb in each hole.

  • You should be able to feel the rubber belt.

  • Gently pull the belt with each thumb, keeping the belt taut around the inner ring.

Voeg opmerking toe

Secure platter back on turntable while keeping belt taut. Pull belt around motor spindle.
  • Secure platter back on turntable while keeping belt taut.

  • Pull belt around motor spindle.

  • Gently let go of belt.

Voeg opmerking toe

Test turntable by spinning the platter.
  • Test turntable by spinning the platter.

  • There should be slight tension causing the platter to come to a stop.

Voeg opmerking toe

Eindstreep

Één andere persoon heeft deze handleiding voltooid.

Nikolai

Lid sinds: 12-10-11

161 reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 17-14, Regan Fall 2011 Lid van Cal Poly, Team 17-14, Regan Fall 2011

CPSU-REGAN-F11S17G14

4 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 3

Afgelopen 7 Dagen: 12

Afgelopen 30 Dagen: 51

Altijd: 2,786