Using a plastic pry, get between the plastic frame and the rest of the phone.
  • Using a plastic pry, get between the plastic frame and the rest of the phone.

  • Move it along the frame unlocking the locks that keep the frame in place.

  • Remove the plastic frame.

  • Be careful not to pry to hard and crack the plastic frame.

Voeg opmerking toe

Using a T-5 screw driver, unscrew the screws on the four corners of the phone.
  • Using a T-5 screw driver, unscrew the screws on the four corners of the phone.

  • Using a pry, get between the screen cover and the rest of the phone.

  • Move alone this layer unlocking the various locks that keep it in place.

  • Carefully remove the screen cover to reveal the logic board.

  • Keep track of the four small screws. They will be needed to put the phone back together.

Voeg opmerking toe

  • Disconnect the flex cable from the logic board.

  • Disconnect the camera from the logic board.

  • Disconnect the LCD display screen.

  • Disconnect the LCD phone screen.

  • Carefully remove the broken logic board by freeing it from the various locks holding it in place.

  • Be careful not to touch either of the screens. You can leave finger prints and damage the screens.

Voeg opmerking toe

  • Take the new logic board and connect all the parts you just disconnected to their correct locations.

Voeg opmerking toe

  • Place the cover so that it is in the correct position to be re-installed.

  • Press gently on the cover so that it snaps back into place.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Adrianna

Lid sinds: 18-04-12

25 Reputatie

2 handleidingen geschreven

Team

SUNY Cortland, Team 1-2, Getto Spring 2012 Lid van SUNY Cortland, Team 1-2, Getto Spring 2012

SUNYCORT-GETTO-S12S1G2

2 Leden

8 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 4

Afgelopen 30 Dagen: 6

Altijd: 1,378