Ga door naar hoofdinhoud

Nintendo Wii Remote Speaker Replacement

Wat je nodig hebt

  1. Nintendo Wii Remote Speaker Replacement, Front Cover Plate and Batteries: stap 1, afbeelding 1 van 2 Nintendo Wii Remote Speaker Replacement, Front Cover Plate and Batteries: stap 1, afbeelding 2 van 2
    • Flip the Wii Remote over so the battery cover faces you.

    • Push up on the bottom tab.

    • Remove the battery cover.

  2. Nintendo Wii Remote Speaker Replacement: stap 2, afbeelding 1 van 1
    • Remove the first battery by pressing down on the positive end and pulling the battery out.

    • Remove the second battery by pushing up on the positive end and pulling the battery out.

  3. Nintendo Wii Remote Speaker Replacement: stap 3, afbeelding 1 van 1
    • Using a tri-point Y1 Screwdriver, remove the two center 7mm screws by turning them counterclockwise.

    • Repeat with the two bottom screws.

  4. Nintendo Wii Remote Speaker Replacement: stap 4, afbeelding 1 van 2 Nintendo Wii Remote Speaker Replacement: stap 4, afbeelding 2 van 2
    • With the flat end of a spudger, gently apply pressure to the tabs located on left side of the controller.

    • These tabs are breakable. However, if the tabs are broken the controller will still function.

    • Open the front plate like a book.

    • Small parts may fall out as you open the front plate.

    Mine is not opening like a book? What do I do?

    Micah Thompson - Antwoord

    It stops short of explaining replacing rechargeable battery. Unless you’re referring to the AA’s which don’t involve removing cover

    Sticky Insides - Antwoord

  5. Nintendo Wii Remote Speaker Replacement, Speaker: stap 5, afbeelding 1 van 3 Nintendo Wii Remote Speaker Replacement, Speaker: stap 5, afbeelding 2 van 3 Nintendo Wii Remote Speaker Replacement, Speaker: stap 5, afbeelding 3 van 3
    • Place the plastic opening tool between the edge of the speaker and the wii remote.

    • Gently lift the speaker out of the body of the Wii remote.

    In my Wii controller, the speaker is connected to two cables instead of touching the motherboard.

    Santi12008 - Antwoord

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Emily

Lid sinds: 04/14/13

1.494 Reputatie

6 handleidingen geschreven

Team

Cal Poly, Team 3-44, Amido Spring 2013 Lid van Cal Poly, Team 3-44, Amido Spring 2013

CPSU-AMIDO-S13S3G44

4 Leden

26 handleidingen geschreven

Één opmerking

Thank you, u help me to fix it.

joon lew - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 1

Afgelopen 7 dagen: 18

Afgelopen 30 dagen: 82

Altijd: 6,686