Ga door naar hoofdinhoud

Inleiding

If your 3DS joystick is not responding, follow these steps to replace the joystick pad and get your device working again. Watch out for delicate ribbon cables in the device. There is a loose black washer in the joystick housing. Be sure not to lose it.

  1. Nintendo 3DS 2015 Joystick Pad Replacement, Battery: stap 1, afbeelding 1 van 1
    • Unscrew the two 3mm Phillips #0 head screws along the top edge of the device.

    • The screws on the back panel strip easily. Go slowly and press down firmly.

    • The screws on the back panel are held in by locking washers, so they won't come out of the back panel.

  2. Nintendo 3DS 2015 Joystick Pad Replacement: stap 2, afbeelding 1 van 2 Nintendo 3DS 2015 Joystick Pad Replacement: stap 2, afbeelding 2 van 2
    • Pull the top corner tabs of the front face plate outward and towards you.

    • Pull the faceplate up and out of the slots at the bottom of the device.

    • Set aside the back faceplate.

  3. Nintendo 3DS 2015 Joystick Pad Replacement: stap 3, afbeelding 1 van 3 Nintendo 3DS 2015 Joystick Pad Replacement: stap 3, afbeelding 2 van 3 Nintendo 3DS 2015 Joystick Pad Replacement: stap 3, afbeelding 3 van 3
    • Insert a plastic opening tool into the notch at the top of the battery.

    • Pry the battery up with the plastic opening tool.

  4. Nintendo 3DS 2015 Joystick Pad Replacement, SD Card Reader: stap 4, afbeelding 1 van 1
    • Unscrew the three 3mm Y0 screws along the right and bottom of the SD card reader.

    • The bottom of the SD card reader should slightly pop out after removing the screws.

  5. Nintendo 3DS 2015 Joystick Pad Replacement: stap 5, afbeelding 1 van 1
    • Pull the SD card reader from the edge with two holes gently to free the tab at the top of the SD card reader.

    • Don't completely pull the SD card out of the device yet. There is a ribbon cable connected under the SD card reader.

    • Reorient the device so that the power jack faces you.

  6. Nintendo 3DS 2015 Joystick Pad Replacement: stap 6, afbeelding 1 van 2 Nintendo 3DS 2015 Joystick Pad Replacement: stap 6, afbeelding 2 van 2
    • Lift the SD card reader gently.

    • Use a plastic opening tool to pry the SD card ribbon cable off the socket on the motherboard.

    • Lift the SD card reader out off of the lower casing.

  7. Nintendo 3DS 2015 Joystick Pad Replacement, Lower Case: stap 7, afbeelding 1 van 3 Nintendo 3DS 2015 Joystick Pad Replacement, Lower Case: stap 7, afbeelding 2 van 3 Nintendo 3DS 2015 Joystick Pad Replacement, Lower Case: stap 7, afbeelding 3 van 3
    • Reorient the device so that the game slot now faces you.

    • Remove the two rubber bumpers along the top of the device using tweezers.

    • Unscrew the seven 6mm Phillips #00 screws along the top and bottom of the 3DS.

  8. Nintendo 3DS 2015 Joystick Pad Replacement: stap 8, afbeelding 1 van 2 Nintendo 3DS 2015 Joystick Pad Replacement: stap 8, afbeelding 2 van 2
    • Lift the top edge of the lower case slightly off on the 3DS.

    • Don't pull the lower casing completely off, you may break those connections. There are ribbon cables that must be disconnected first.

    • Pry the ribbon cable socket under the right trigger using a plastic opening tool.

    • Pry the ribbon cable socket under the infrared receiver cover using a plastic opening tool.

  9. Nintendo 3DS 2015 Joystick Pad Replacement: stap 9, afbeelding 1 van 3 Nintendo 3DS 2015 Joystick Pad Replacement: stap 9, afbeelding 2 van 3 Nintendo 3DS 2015 Joystick Pad Replacement: stap 9, afbeelding 3 van 3
    • Open the device slowly from its top edge. Be careful not to tug the ribbon cable connected near the bottom edge of the device.

    • Pry the last ribbon cable attached to the lower case using a plastic opening tool.

  10. Nintendo 3DS 2015 Joystick Pad Replacement, Joystick: stap 10, afbeelding 1 van 3 Nintendo 3DS 2015 Joystick Pad Replacement, Joystick: stap 10, afbeelding 2 van 3 Nintendo 3DS 2015 Joystick Pad Replacement, Joystick: stap 10, afbeelding 3 van 3
    • Locate the joystick assembly near the top right corner of the motherboard.

    • Remove the two 8mm Phillips #00 screws from the back of the joystick.

    • Use the flat end of the spudger to pry off the joystick pad from its plastic housing.

  11. Nintendo 3DS 2015 Joystick Pad Replacement: stap 11, afbeelding 1 van 2 Nintendo 3DS 2015 Joystick Pad Replacement: stap 11, afbeelding 2 van 2
    • Lift the joystick pad and place it on its back. This will reveal the ribbon cable connected to the joystick pad.

    • Use the flat end of the spudger to pry up the retaining flap for the ribbon cable.

    • Lift the joystick out of the device.

Conclusie

To reassemble your device, follow these instructions in reverse order.

4 andere personen hebben deze handleiding voltooid.

Michael

Lid sinds: 14-10-16

149 Reputatie

1 Handleiding geschreven

Team

Cal Poly, Team 4-6, Livingston Fall 2016 Lid van Cal Poly, Team 4-6, Livingston Fall 2016

CPSU-LIVINGSTON-F16S4G6

4 Leden

35 handleidingen geschreven

Één opmerking

thank you for the help

Crichton Vance - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 6

Afgelopen 7 dagen: 23

Afgelopen 30 dagen: 97

Altijd: 3,606