Ga door naar hoofdinhoud

Nintendo 2DS Rear Panel Replacement

Wat je nodig hebt

  1. Nintendo 2DS Rear Panel Replacement, Rear Panel: stap 1, afbeelding 1 van 1
    • Remove the ten Phillips screws attaching the rear panel.

  2. Nintendo 2DS Rear Panel Replacement: stap 2, afbeelding 1 van 1
    • The rear panel is attached to the motherboard by a ribbon cable, so be careful not to lift the rear panel too far from the device.

    • Carefully pull the rear panel straight up from the device.

  3. Nintendo 2DS Rear Panel Replacement: stap 3, afbeelding 1 van 1
    • Use your fingernail or the flat end of a spudger to flip up the connector securing the ribbon cable to the motherboard

    • Remove the cable from the connector

    • Take the opportunity to remove the Left and Right triggers, they have hinges that may break and springs that may jump away.

Conclusie

To reassemble your device, follow these instructions in reverse order.

9 andere personen hebben deze handleiding voltooid.

Fina Beauchamp

Lid sinds: 01/12/15

2.988 Reputatie

6 handleidingen geschreven

Team

Cal Poly, Team 70-1, Forte Winter 2015 Lid van Cal Poly, Team 70-1, Forte Winter 2015

CPSU-FORTE-W15S70G1

4 Leden

35 handleidingen geschreven

2 opmerkingen

The two top screws on the backpanel I cannot get out, I used the same screwdriver I used for every other screw.

Please help!

Evergreen - Antwoord

For those two screws that are on the top cap aren’t supposed to come out, if the do come out it means you’ve broken those screws. Also after unscrewing that top it should just slide up.

Leo Ochoa -

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 2

Afgelopen 7 dagen: 25

Afgelopen 30 dagen: 122

Altijd: 13,239