Ga door naar hoofdinhoud

Ninja Professional BL610 LED Replacement

Wat je nodig hebt

  1. Ninja Professional BL610 LED Replacement, LED: stap 1, afbeelding 1 van 1
    • Remove six screws (12mm long, 6mm head diameter) from bottom of the blender using a Phillips #2 screwdriver.

  2. Ninja Professional BL610 LED Replacement: stap 2, afbeelding 1 van 1
    • Remove six screws (12mm long, 6mm head diameter) from component housing using Phillips #2 screwdriver.

  3. Ninja Professional BL610 LED Replacement: stap 3, afbeelding 1 van 1
    • Remove five screws from circuit board using Phillips #2 screwdriver.

  4. Ninja Professional BL610 LED Replacement: stap 4, afbeelding 1 van 1
    • Once the screws are removed, lift the circuit board to access the back.

  5. Ninja Professional BL610 LED Replacement: stap 5, afbeelding 1 van 1
    • Locate the LED you wish to replace and note its position on the opposite side of the circuit board.

  6. Ninja Professional BL610 LED Replacement: stap 6, afbeelding 1 van 1
    • Desolder both of the LED leads and remove the LED light. Note the orientation of LED, this is important for replacing the LED. The Replacement LED needs to be soldered in the same orientation.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Rosniel Castro

Lid sinds: 09/27/17

482 Reputatie

4 handleidingen geschreven

Team

USF Tampa, Team S14-G3, Boczar Fall 2017 Lid van USF Tampa, Team S14-G3, Boczar Fall 2017

USFT-BOCZAR-F17S14G3

4 Leden

4 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 4

Altijd: 140