Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Inleiding

Removing the battery door makes it easier to clean up after a battery leak or unscrew the bottom panel. It is also necessary for the installation of certain accessories.

  1. On the bottom of the camera, pull the release tab towards the center of the camera, then pull up. On the bottom of the camera, pull the release tab towards the center of the camera, then pull up.
    • On the bottom of the camera, pull the release tab towards the center of the camera, then pull up.

  2. Grip and hold the front end of the battery door at a 45-degree angle from the case. Pop the battery door out by pulling the front tab up.
    • Grip and hold the front end of the battery door at a 45-degree angle from the case.

    • Pop the battery door out by pulling the front tab up.

    • When reassembling, seat the rear tab in its slot before pushing the front tab back in.

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Jacob Rardin

Lid sinds: 14-04-14

1.294 Reputatie

6 handleidingen geschreven

Team

Cal Poly, Team 13-28, Maness Spring 2014 Lid van Cal Poly, Team 13-28, Maness Spring 2014

CPSU-MANESS-S14S13G28

4 Leden

6 handleidingen geschreven

Één commentaar

My problem is the door on my Nikon D850 broke, leaving the small part with the two prongs in place, and I don’t know how to get them out to install a replacement door. Would appreciate suggestions tootswaller22@gmail.com

Harry Langdon - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 5

Afgelopen 30 dagen: 30

Altijd: 2,492