Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Inleiding

If you can see black rings around the outside of the image preview, the lens may not be mounted correctly or the lens mounting ring has worn down and no longer holds the lens in position. If you have this problem use this guide to reseat or replace the lens mounting ring.

Onderdelen

  1. Remove the 6 Phillips screws on the front of the lens mounting ring.
    • Remove the 6 Phillips screws on the front of the lens mounting ring.

  2. Nintendo Switch-kits

    Een snelle oplossing die je weer mee laat doen

    Koop Switchkits

    Nintendo Switch-kits

    Een snelle oplossing die je weer mee laat doen

    Koop Switchkits
  3. Carefully lift the mounting ring straight up.
    • Carefully lift the mounting ring straight up.

    • Three unfastened metal plates lie under the lens mounting ring, be very careful lifting it up as to not disturb them.

  4. Reseat or replace the lens mounting ring and reassemble. The locating pin on the right of the camera will help place the mounting ring properly.
    • Reseat or replace the lens mounting ring and reassemble.

    • The locating pin on the right of the camera will help place the mounting ring properly.

    • The small metal plates marked in the image are not fastened and may displace if the camera if tipped or bumped. Be sure these are properly in place before reassembly.

Conclusie

To reassemble your device, follow these instructions in reverse order.

8 andere personen hebben deze handleiding voltooid.

Taylor

Lid sinds: 30-01-15

1.165 Reputatie

5 handleidingen geschreven

Team

USF Tampa, Team 16-6, Watkins Winter 2015 Lid van USF Tampa, Team 16-6, Watkins Winter 2015

USFT-WATKINS-W15S16G6

2 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 1

Afgelopen 30 dagen: 8

Altijd: 3,109