Onderdelen

Geen onderdelen nodig.

  1. Turn over camera to find 5 apparent screws.
    • Turn over camera to find 5 apparent screws.

    Voeg opmerking toe

  2. Remove all 5 screws from the bottom of the camera and store them carefully.
    • Remove all 5 screws from the bottom of the camera and store them carefully.

    Voeg opmerking toe

    • Open battery door by sliding it in the direction of the arrow to reveal a hidden screw on the opposite side of orange lever. Remove this screw.

    Voeg opmerking toe

    • Rotate camera to find side panel with lanyard attachment. Detach side panel by lifting bottom corner slightly with the spudger.

    Voeg opmerking toe

    • Lift the back cover, being careful not to rip the orange cables between the camera and the back cover.

    Voeg opmerking toe

    • With back cover lifted, lift the black flap that connects the ribbon to the motherboard with the spudger and carefully remove the back cover.

    Voeg opmerking toe

    • On back of LCD screen, locate the three screws underneath the ribbon and remove them.

    Voeg opmerking toe

    • Take out rectangular component on the side where the screws were.

    • Pry apart screen from back casing using the spudger.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Ryan

Lid sinds: 12-04-11

131 Reputatie

6 handleidingen geschreven

Team

Cal Poly, Team 18-24, Garner Spring 2011 Lid van Cal Poly, Team 18-24, Garner Spring 2011

CPSU-GARNER-S11S18G24

4 Leden

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 2

Afgelopen 30 Dagen: 4

Altijd: 2,121