Ga door naar hoofdinhoud

Deze handleiding heeft recentere wijzigingen. Schakel over naar de nieuwste niet-geverifieerde versie.

Nikon Coolpix S220 Accessing the Motherboard

Wat je nodig hebt

  1. Nikon Coolpix S220 Accessing the Motherboard, Outer Cover: stap 1, afbeelding 1 van 1
    • Remove the two 2.8 mm screws on the left side of the camera.

  2. Nikon Coolpix S220 Accessing the Motherboard: stap 2, afbeelding 1 van 1
    • Remove the four 2.8 mm screws on the right side of the camera.

  3. Nikon Coolpix S220 Accessing the Motherboard: stap 3, afbeelding 1 van 1
    • Remove the three 4.1 mm screws on the bottom of the camera.

  4. Nikon Coolpix S220 Accessing the Motherboard: stap 4, afbeelding 1 van 1
    • Gently lift the rear cover from the camera.

  5. Nikon Coolpix S220 Accessing the Motherboard, LCD: stap 5, afbeelding 1 van 1
    • Gently lift the screen out of its place.

    • You will need to hold the screen slightly above the camera because it will still be attached to the camera by an orange ribbon cable.

  6. Nikon Coolpix S220 Accessing the Motherboard: stap 6, afbeelding 1 van 1
    • Use the tweezers to lift the ZIF connector which is holding the ribbon cables that connect the LCD screen to the motherboard.

  7. Nikon Coolpix S220 Accessing the Motherboard: stap 7, afbeelding 1 van 1
    • Slowly pull the screen from the camera.

  8. Nikon Coolpix S220 Accessing the Motherboard, Motherboard: stap 8, afbeelding 1 van 1
    • Remove the four 3.8 mm screws located near the bottom right and top left of the LCD base plate.

  9. Nikon Coolpix S220 Accessing the Motherboard: stap 9, afbeelding 1 van 1
    • Lift up silver LCD base plate

  10. Nikon Coolpix S220 Accessing the Motherboard: stap 10, afbeelding 1 van 2 Nikon Coolpix S220 Accessing the Motherboard: stap 10, afbeelding 2 van 2
    • Using tweezers, lift up the retaining flap on the ZIF connector securing the button panel ribbon cable.

    • Slide the button panel ribbon cable out of its socket on the motherboard.

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Shauna

Lid sinds: 04/05/11

798 Reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 12-32, Maness Spring 2011 Lid van Cal Poly, Team 12-32, Maness Spring 2011

CPSU-MANESS-S11S12G32

4 Leden

10 handleidingen geschreven

Één opmerking

It would be nice to have a guide for replacing the flash capacitor.

danwat1234 - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 7

Altijd: 5,609