Inleiding

This guide will show how to access the motherboard which will give you the ability to remove the lens and flash.

Onderdelen

Geen onderdelen nodig.

Remove the two 2.8 mm screws on the left side of the camera.
  • Remove the two 2.8 mm screws on the left side of the camera.

Voeg opmerking toe

Remove the four 2.8 mm screws on the right side of the camera.
  • Remove the four 2.8 mm screws on the right side of the camera.

Voeg opmerking toe

Remove the three 4.1 mm screws on the bottom of the camera.
  • Remove the three 4.1 mm screws on the bottom of the camera.

Voeg opmerking toe

Gently lift the rear cover from the camera.
  • Gently lift the rear cover from the camera.

Voeg opmerking toe

Gently lift the screen out of its place.
  • Gently lift the screen out of its place.

  • You will need to hold the screen slightly above the camera because it will still be attached to the camera by an orange ribbon cable.

Voeg opmerking toe

Use the tweezers to lift the ZIF connector which is holding the ribbon cables that connect the LCD screen to the motherboard.
  • Use the tweezers to lift the ZIF connector which is holding the ribbon cables that connect the LCD screen to the motherboard.

Voeg opmerking toe

Slowly pull the screen from the camera.
  • Slowly pull the screen from the camera.

Voeg opmerking toe

Remove the four 3.8 mm screws located near the bottom right and top left of the LCD base plate.
  • Remove the four 3.8 mm screws located near the bottom right and top left of the LCD base plate.

Voeg opmerking toe

Lift up silver LCD base plate
  • Lift up silver LCD base plate

Voeg opmerking toe

Using tweezers, lift up the retaining flap on the ZIF connector securing the button panel ribbon cable. Slide the button panel ribbon cable out of its socket on the motherboard.
  • Using tweezers, lift up the retaining flap on the ZIF connector securing the button panel ribbon cable.

  • Slide the button panel ribbon cable out of its socket on the motherboard.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Shauna

Lid sinds: 05-04-11

750 reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 12-32, Maness Spring 2011 Lid van Cal Poly, Team 12-32, Maness Spring 2011

CPSU-MANESS-S11S12G32

4 Leden

5 handleidingen geschreven

Één commentaar

It would be nice to have a guide for replacing the flash capacitor.

danwat1234 - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 1

Altijd: 5,219