Deze versie kan foutieve bewerkingen bevatten. Schakel over naar de recentste gecontroleerde momentopname.
Wat je nodig hebt
-
Deze stap is niet vertaald. Help het te vertalen
-
Use your finger to push the latch of the compartment door to the center of the camera body, per image 1.
-
Push the door open, and remove the existing battery with your fingers, per images 2-3.
-
-
Deze stap is niet vertaald. Help het te vertalen
-
Remove both 4.5 mm screws holding the bottom into place.
-
Remove both 4.5 mm screws holding the side into place.
-
Remove the 4.5 mm screw underneath the A/V flap.
-
Remove the 4.0 mm screw on the left-side wrist strap loop.
-
-
Deze stap is niet vertaald. Help het te vertalen
-
Lift up the LCD screen to reveal the two screws.
-
Using a Phillips #000 Precision Screwdriver, remove the two 3.0 mm screws that hold the arm in place.
-
-
-
Deze stap is niet vertaald. Help het te vertalen
-
Press your finger on the top of the latch and pull it down and towards you to open the safety latch and free the ribbon.
-
Slide the ribbon out from its socket.
-
-
Deze stap is niet vertaald. Help het te vertalen
-
Using a Phillips #000 Precision Screwdriver, remove the two 6.0 mm screws from the inner back panel that hold the LCD screen arm in place.
-
-
Deze stap is niet vertaald. Help het te vertalen
-
Using a Phillips #000 Precision Screwdriver, remove the two 3.0 mm screws.
-
Remove the plastic cover from the LCD screen arm.
-
-
Deze stap is niet vertaald. Help het te vertalen
-
Lift and rotate the plastic connector counter-clockwise, clockwise, then counter-clockwise again.
-
Remove the plastic connector from the LCD screen arm.
-
-
Deze stap is niet vertaald. Help het te vertalen
-
Using a Phillips #000 Precision Screwdriver, remove the two 4.0 mm screws.
-
Take off the plastic covering to reveal the inner components of the LCD screen.
-
-
Deze stap is niet vertaald. Help het te vertalen
-
Using a Phillips #000 Precision Screwdriver, remove the four 3.0 mm screws.
-
Using your fingers, remove the two plastic borders that case the LCD screen.
-
-
Deze stap is niet vertaald. Help het te vertalen
-
Using a Phillips #000 Precision Screwdriver, remove both 3.5 mm screws from either side of the LCD screen.
-
Remove the LCD screen from the screen cover.
-
Annuleren: ik heb deze handleiding niet afgemaakt.
2 andere personen hebben deze handleiding voltooid.
4 opmerkingen
Hello Elizabeth,
I have just followed the video’s for replacing a screen on my Coolpix P90.
The procedure was excellent and for an old Australian (born 1931) I never had a problem.
Just one question, is there a special way for reconnecting the data transfer ribbon.
Just cannot reconnect.
Thank you.
Regards, Noman
QLD Australia.
Help! I must be missing something. I only need to replace the screen and I can’t get the angled screen to lay flat. Because of this I cant access the two screws on the back “extension” piece allowing me to remove the plastic cover on the back of the screen. The camera is a coolpix P90. Any advice?
I also need to know where to buy a new screen.
Everywhere I look on line there are only parts listed for newer models.
Thanks, Allen