Repareer je spullen Gemeenschap Winkel

Nikon Coolpix P510 LCD Replacement

Inleiding

If you are having issues with your LCD, this guide will help you replace it with a minimal effort. This part is easy to get to, and easy to replace. Other than a screwdriver and a plastic opening tool, nothing else is needed to accomplish this.

Wat je nodig hebt

  1. Nikon Coolpix P510 LCD Replacement, Battery Removal: stap 1, afbeelding 1 van 1

    • Flip the camera over and push the tab on the battery cover to open the battery compartment.

    Bewerken

  2. Nikon Coolpix P510 LCD Replacement: stap 2, afbeelding 1 van 2 Nikon Coolpix P510 LCD Replacement: stap 2, afbeelding 2 van 2

    • Push the little yellow tab to allow the battery to slide out.

    • With the tab pushed out, pull the battery out.

    Bewerken

  3. Nikon Coolpix P510 LCD Replacement, LCD Screen Window: stap 3, afbeelding 1 van 2 Nikon Coolpix P510 LCD Replacement, LCD Screen Window: stap 3, afbeelding 2 van 2

    • Extend the LCD screen out and turn the camera upside down to get access to the screws on the bottom.

    Bewerken

  5. Nikon Coolpix P510 LCD Replacement: stap 4, afbeelding 1 van 2 Nikon Coolpix P510 LCD Replacement: stap 4, afbeelding 2 van 2

    • Take the four 4mm PH00 Phillips screws out.

    Bewerken

  6. Nikon Coolpix P510 LCD Replacement: stap 5, afbeelding 1 van 2 Nikon Coolpix P510 LCD Replacement: stap 5, afbeelding 2 van 2

    • Use a plastic opening tool to trace around the screen to pop the front and back section apart.

    Bewerken

  7. Nikon Coolpix P510 LCD Replacement, LCD: stap 6, afbeelding 1 van 2 Nikon Coolpix P510 LCD Replacement, LCD: stap 6, afbeelding 2 van 2

    • Tilt the LCD up to get access to the back of it.

    Bewerken

  8. Nikon Coolpix P510 LCD Replacement: stap 7, afbeelding 1 van 2 Nikon Coolpix P510 LCD Replacement: stap 7, afbeelding 2 van 2

    • Unplug the ribbon cables on the side of the chip under the LCD by simple pulling lightly on them.

    Bewerken

  9. Nikon Coolpix P510 LCD Replacement: stap 8, afbeelding 1 van 1

    • The chip has an adhesive on it to keep it attached to the LCD, and you will need to use a plastic opening tool to get it off.

    • It may take a little bit of pressure to get the chip off. Be gentle to make sure you don't break the chip.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

5 andere personen hebben deze handleiding voltooid.

Auteur

met 4 andere bijdragers

Brian Hulsey

Lid sinds: 03/31/15

1.461 Reputatie

6 handleidingen geschreven

Medailles: 13

+10 andere badges

Team

Colorado Springs, Team 2-2, Panko Spring 2015 Lid van Colorado Springs, Team 2-2, Panko Spring 2015

UCCS-PANKO-S15S2G2

3 Leden

12 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 4

Afgelopen 7 dagen: 19

Afgelopen 30 dagen: 67

Altijd: 5,495