Inleiding

In order to reach the internal elements of the camera (lens, flashbulb, etc.), the following steps will tell you how to remove the front cover.

Onderdelen

Geen onderdelen nodig.

  1. Remove the memory stick from the camera.
    • Remove the memory stick from the camera.

    • Remove the batteries from the camera.

    Voeg opmerking toe

  2. Remove all six 4.3mm silver screws along the perimeter of the camera using the Phillips #00 screwdriver.
    • Remove all six 4.3mm silver screws along the perimeter of the camera using the Phillips #00 screwdriver.

    • There is one screw hidden under the AV cover that also needs to be removed.

    Voeg opmerking toe

    • Pry the back cover from the left side of the camera. Remove the cover gently.

    Voeg opmerking toe

  3. Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    • CAUTION! This is where energy for the flash is stored. Even with batteries removed, if you touch these connections, you can be shocked, depending on if the flash capacitor has a stored charge. It may not have a stored charge, but work around this assuming it does.

    • Newer cameras of descent quality usually have a bleeder resistor to drain the flash capacitor. This may not work anymore and the flash capacitor may still have a charge.

    Voeg opmerking toe

    • Remove the tape on the right side of the LCD screen.

    • Gently lift the LCD screen from its base.

    • Don't tug on the screen because it is still connected to the logic board.

    Be very careful not to touch the flash capacitor on far left when lifting the LCD!! It WILL shock you.

    Mark Fraylick - Antwoord

    Getting the LCD ribbon back "in" is my problem -- hints or suggestions?

    richardkujawa - Antwoord

    I can't get a feel for how the black clip holds the ribbon - insert the new one at an angle?

    richardkujawa - Antwoord

    I practiced a few times with the "bad screen" and managed to figure this out. Unfortunately I can't explain how I did it... if some other person can explain how to make the ribbon connection/clip re-install more predictable I think it'd help anyone else who tries the repair.

    richardkujawa - Antwoord

    • Lift the black latch connecting the LCD ribbon to the logic board.

    • Gently pull the LCD ribbon out.

    Voeg opmerking toe

    • Pry back the front cover of the camera starting from the right side.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Andrea Govea

Lid sinds: 11-10-10

357 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 9-23, Regan Fall 2010 Lid van Cal Poly, Team 9-23, Regan Fall 2010

CPSU-REGAN-F10S9G23

4 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 2

Afgelopen 30 Dagen: 13

Altijd: 2,917