Inleiding

This guide will walk you through the necessary steps to remove the back panel of the Nikon Coolpix E5700.

Onderdelen

Geen onderdelen nodig.

Use your finger tip to slide the battery release tab toward the battery symbol on the E5700. Open the battery door.
  • Use your finger tip to slide the battery release tab toward the battery symbol on the E5700.

  • Open the battery door.

Voeg opmerking toe

Pull the battery out of the E5700.
  • Pull the battery out of the E5700.

  • It may be necessary to wiggle the battery while pulling to free it from its pocket in the case.

Voeg opmerking toe

Turn to the bottom of the camera.
  • Turn to the bottom of the camera.

  • Remove the two Phillips screws located directly below the back monitor

Voeg opmerking toe

Mac RAM Kits
Versnel je Mac. Breid zijn geheugen uit.
Mac RAM Kits
Haal meer megabytes uit je Mac.
Turn the camera to the side with the memory card slot and open the compartment for the CF card. Remove the top two Phillips screws closest to the back panel.
  • Turn the camera to the side with the memory card slot and open the compartment for the CF card.

  • Remove the top two Phillips screws closest to the back panel.

Voeg opmerking toe

Turn to the back of the camera.
  • Turn to the back of the camera.

  • Remove the top most Phillips screw on the back panel.

Voeg opmerking toe

Turn to the last side of the back panel.
  • Turn to the last side of the back panel.

  • Remove the Phillips screw below the eyepiece.

  • Remove the Phillips screw located above the speaker.

Voeg opmerking toe

Gently begin to remove the back panel. Caution: There are two bundles of wires connecting the back panel to the camera. Be sure not to pull too hard and yank these out.
  • Gently begin to remove the back panel.

    • Caution: There are two bundles of wires connecting the back panel to the camera. Be sure not to pull too hard and yank these out.

Before pulling the panel. You MUST remove first de rubber bumper ( arrond the ocular piece ).

diego - Antwoord

Now gently unplug the two wires at the bottom of the panel. Now gently unplug the two wires at the bottom of the panel.
  • Now gently unplug the two wires at the bottom of the panel.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Raana

Lid sinds: 12-04-11

57 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 24-58, Amido Spring 2011 Lid van Cal Poly, Team 24-58, Amido Spring 2011

CPSU-AMIDO-S11S24G58

4 Leden

9 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 6

Altijd: 1,673