Inleiding

Use this guide to replace the front cover.

Onderdelen

Geen onderdelen nodig.

Remove the four 3.0mm screws on the bottom of the camera.
  • Remove the four 3.0mm screws on the bottom of the camera.

Voeg opmerking toe

Remove the two 3.0mm screws on the left side of the camera near the memory card compartment.
  • Remove the two 3.0mm screws on the left side of the camera near the memory card compartment.

Voeg opmerking toe

  • Remove the two 3.0mm screws on the right side of the camera.

Voeg opmerking toe

  • Carefully open the back cover. Take care as there are connectors still attached.

Voeg opmerking toe

  • Disconnect the cable by pulling the head upward along the green circuit board. If you only are changing the LCD, skip this step.

Voeg opmerking toe

  • Disconnect the ribbon cable by grabbing the two handles and pulling it directly out of the socket. If you are only changing LCD, skip this step.

  • The back cover will be disconnected from the camera

Voeg opmerking toe

  • Be careful of metallic parts which are loose and will fall out.

  • Remove the two 2.5mm screws on the bottom of the left side, after having removed the back cover.

Voeg opmerking toe

  • Remove the two 3.0mm screws on the right side of the camera.

Voeg opmerking toe

  • Remove front cover.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Kaky Payne

Lid sinds: 17-04-12

58 Reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 12-38, Regan Spring 2012 Lid van Cal Poly, Team 12-38, Regan Spring 2012

CPSU-REGAN-S12S12G38

4 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 2

Altijd: 1,044