Inleiding

This guide is to be used to install the wrist strap holder in the case that the holder becomes damaged or no longer functioning properly due to overuse. A Phillips screwdriver will be needed to complete this installation.

Onderdelen

Geen onderdelen nodig.

Remove the wrist strap from the wrist strap holder by untying the string at the end of the wrist strap.
  • Remove the wrist strap from the wrist strap holder by untying the string at the end of the wrist strap.

    • This will allow for the wrist strap to be pulled through the wrist strap holder.

Voeg opmerking toe

Using the thumb, firmly push the Battery/SD cover in the middle and in the direction of the arrow on the Battery/SD cover.
  • Using the thumb, firmly push the Battery/SD cover in the middle and in the direction of the arrow on the Battery/SD cover.

    • This will cause the Battery/SD cover to pop open.

Voeg opmerking toe

  • Use the Phillips screwdriver to remove the four screws on the bottom of the camera.

Voeg opmerking toe

  • Using fingers, pull the silver side panels from each side.

Voeg opmerking toe

  • On the right hand side of the camera, remove the two screws from the wrist strap handle by using the Phillips screwdriver.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Patty Richeson

Lid sinds: 11-03-13

75 Reputatie

4 handleidingen geschreven

Team

Clemson, Team 12-5, Benson Spring 2013 Lid van Clemson, Team 12-5, Benson Spring 2013

CLEM-BENSON-S13S12G5

4 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 2

Altijd: 426