Repareer je spullen

Recht op reparatie

Winkel

Nexus Q NFC Antenna Replacement

Geschreven door: Alex Thomas (en 5 andere bijdragers)
  • Reacties: 1
  • Favorieten: 0
  • Voltooide reparaties: 1

Moeilijkheid

Eenvoudig

Stappen

7

Tijd vereist

15 minuten

Secties

3

Markeringen

0

Inleiding

This is a relatively easy repair to make to your Q. Follow the prerequisite for removing the inner dome daughterboard to get started.

  1. Squeeze and pull to pop the cap off of the Nexus Q.

    • Squeeze and pull to pop the cap off of the Nexus Q.

    Bewerken

  2. Disconnect the taoglas Wi-Fi Dual Band Antenna by prying with a spudger. Once the antenna is disconnected, simply pull it off the outside of the inner dome.

    • Disconnect the taoglas Wi-Fi Dual Band Antenna by prying with a spudger.

    • Once the antenna is disconnected, simply pull it off the outside of the inner dome.

    Bewerken

  3. Undo the ZIF connector by prying with a spudger.

    • Undo the ZIF connector by prying with a spudger.

    Bewerken

  4. De essentiële toolkit

    De meest behulpzame tools in onze meest compacte kit.

    Koop nu

    De essentiële toolkit

    De meest behulpzame tools in onze meest compacte kit.

    Koop nu

  5. Use a T10 Torx screwdriver to remove the four 1.3 mm screws holding the inner dome in place.

    • Use a T10 Torx screwdriver to remove the four 1.3 mm screws holding the inner dome in place.

    Bewerken

  6. Use a T6 Torx screwdriver to undo the three 0.8 mm screws holding the inner dome daughterboard in place.

    • Use a T6 Torx screwdriver to undo the three 0.8 mm screws holding the inner dome daughterboard in place.

    Bewerken

  7. Use a spudger to disconnect the daughterboard from the ZIF connector.

    • Use a spudger to disconnect the daughterboard from the ZIF connector.

    Bewerken

  8. Use a spudger to pry out the NFC antenna. The antenna has two layers; be careful not to pry the two layers apart.

    • Use a spudger to pry out the NFC antenna.

    • The antenna has two layers; be careful not to pry the two layers apart.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Auteur

met 5 andere bijdragers

Alex Thomas

Lid sinds: 31-01-13

27 Reputatie

3 handleidingen geschreven

Badges: 3

Team

Cal Poly, Team 7-10, Maness Winter 2013 Lid van Cal Poly, Team 7-10, Maness Winter 2013

CPSU-MANESS-W13S7G10

4 Leden

5 handleidingen geschreven

0 Opmerkingen

Voeg een opmerking toe

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 1

Altijd: 555