Inleiding

Replace your worn out inner dome daughterboard: which contains Atmel ATMEGA328P, NXP Semiconductors 44501 Near-Field Communications Controller, TXC 8.00 MHz Crystal Quartz Oscillator, YF04E, and the status LED.

Squeeze and pull to pop the cap off of the Nexus Q.
  • Squeeze and pull to pop the cap off of the Nexus Q.

Voeg opmerking toe

Disconnect the taoglas Wi-Fi Dual Band Antenna by prying with a spudger. Once the antenna is disconnected, simply pull it off the outside of the inner dome.
  • Disconnect the taoglas Wi-Fi Dual Band Antenna by prying with a spudger.

  • Once the antenna is disconnected, simply pull it off the outside of the inner dome.

Why remove the anntenna? what did it do to you?

rudyt83 - Antwoord

Undo the ZIF connector by prying with a spudger.
  • Undo the ZIF connector by prying with a spudger.

Voeg opmerking toe

Use a T10 Torx screwdriver to remove the four 1.3 mm screws holding the inner dome in place.
  • Use a T10 Torx screwdriver to remove the four 1.3 mm screws holding the inner dome in place.

Voeg opmerking toe

Use a T6 Torx screwdriver to undo the three 0.8 mm screws holding the inner dome daughterboard in place.
  • Use a T6 Torx screwdriver to undo the three 0.8 mm screws holding the inner dome daughterboard in place.

Voeg opmerking toe

Use a spudger to disconnect the daughterboard from the ZIF connector.
  • Use a spudger to disconnect the daughterboard from the ZIF connector.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Alex Thomas

Lid sinds: 31-01-13

27 reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 7-10, Maness Winter 2013 Lid van Cal Poly, Team 7-10, Maness Winter 2013

CPSU-MANESS-W13S7G10

4 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 3

Altijd: 762