Ga door naar hoofdinhoud

Nexus Q Ball Bearing Ring Replacement

Wat je nodig hebt

  1. Nexus Q Ball Bearing Ring Replacement, Ball Bearing Ring: stap 1, afbeelding 1 van 1
    • Squeeze and pull the cap to remove it from the Nexus Q.

  2. Nexus Q Ball Bearing Ring Replacement: stap 2, afbeelding 1 van 1
    • Use a spudger to disconnect the Taoglas Wi-Fi Dual Band Antenna.

  3. Nexus Q Ball Bearing Ring Replacement: stap 3, afbeelding 1 van 1
    • Undo the ZIF connector by prying it with a spudger.

  4. Nexus Q Ball Bearing Ring Replacement: stap 4, afbeelding 1 van 1
    • Use a Phillips #0 screwdriver to unscrew the four 1.3 mm screws.

    • After removing the screws, there will be two parts. The top part contains the daughterboard. Store it safely. It will not be used.

  5. Nexus Q Ball Bearing Ring Replacement: stap 5, afbeelding 1 van 1
    • View the bottom half of the Nexus Q.

    • Use a Phillips #0 screwdriver to remove the four 0.8 mm screws holding the ball bearing ring in place.

  6. Nexus Q Ball Bearing Ring Replacement: stap 6, afbeelding 1 van 1
    • Remove the ball bearing ring.

    • When placing a new ring in its place, make sure to orient it right or the top will not close.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Taewan Kim

Lid sinds: 01/31/13

22 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 7-10, Maness Winter 2013 Lid van Cal Poly, Team 7-10, Maness Winter 2013

CPSU-MANESS-W13S7G10

4 Leden

5 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 2

Altijd: 554