Inleiding
This guide is used to replace the motherboard of the Nest Dropcam Pro if yours has stopped working. Make sure the device is unplugged before opening.
Wat je nodig hebt
-
-
-
Press in the mounting clips on each side of the case to remove the camera from the mount.
Vraag FixBot
-
-
-
Lift the front of the case slowly, as there is an antenna cable attached to the motherboard.
-
Carefully disconnect the antenna cable from the motherboard. You will feel this cable "pop" out of place when disconnected.
-
-
-
-
-
-
Insert a spudger tool under the micro-USB port and lift to separate the motherboard from the back case.
-
-
-
Pull the motherboard away from the back case.
-
Unplug the red and black cable connecting the motherboard to the back case.
-
-
-
Lift the lens and LED assembly away from the motherboard.
-
Unplug the yellow and white cable from the motherboard.
-
-
To reassemble your device, follow these instructions in reverse order.
Annuleren: ik heb deze handleiding niet afgemaakt.
7 andere personen hebben deze handleiding voltooid.
Team
USF Tampa, Team 15-4, Blackwell Fall 2015 Lid van USF Tampa, Team 15-4, Blackwell Fall 2015
USFT-BLACKWELL-F15S15G4
3 Leden
12 handleidingen geschreven
7Gids Commentaar
where we can get the mother board to replace
I need this too
Can't find it either. Silly to write an entire article for credit if parts arent actually available.
searched for the MB online?? Why no mention of where to get it??
